emos ZM5171 LED Panel Surface Mounted User Manual

: June 9, 2024
: EMOS

Table of Contents

emos ZM5171 LED Panel Surface Mounted User Manual
Read User Manual Online (PDF format)
Download This Manual (PDF format)

emos ZM5171 LED Panel Surface Mounted User Manual

ZM5171
ZM5172
ZM5173
ZM5181
ZM5182
ZM5183

www.emos.eu

Illustration 1-4

Remote Control

Turn on/off the light
4 step CCT adjusting
4 step dimming
Scene mode A–10 % Brightness, CCT 2 700 K Scene mode B–30 % Brightness, CCT 4 000 K
Step-less CCT adjusting
All Control
Step-less Dimming
Scene mode C–50 % Brightness, CCT 5 000 K Scene mode D–100 % Brightness, CCT 6 000 K
ID keys, can set the ID of the panel from 0–99
ID Setting key (not in use)
ID key – group setting/selection

The LED light fitting is designed for installation onto a solid base in indoor areas.
Enclosure: IP20 for indoor environments.

Mounting

Mount the lamp firmly onto a solid basis, for example a wall, a ceiling and like that.
Connect the power cord to the mains 230 V~.
Connecting conductor must not be connected to the mains at time of installation. This operation can be carried out only by an authorized person.

N – blue – neutral wire
L – brown – live wire

Pair and Un-pair

Single group pair
a. Turn on the luminaire and finish steps b) and c) in 10 seconds
b. Press any number from 0–99 and then press ID key
c. Repeat step b), the luminaire will blink one time and finish pairing
Note: One remote controller can pair 100 groups of luminaires a no limit in each group
Non-group pair
Turn on the luminaire, press in 10 seconds. The luminaire will blink one time and pairing is finished.

Single group control or all control

Single group control – Press the ID number of the luminaire and then press function key
All control – Press ALL key and then press function keys

WARNING

Luminaire is suitable entirely for fixed mounting.
The luminaire can be connected only to the electric distribution network whose installation and protection complies with the applicable standards.
Before any manipulation or servicing of the luminaire disconnect the luminaire from AC power. This operation can be carried out only by an authorized person.
In case of any damage to any part of the luminaire, don’t use it.
LED chips inside the luminaire are not replaceable.
Don’t change inner wiring of the luminaire.
The protection from dangerous contact voltage is ensured by „earthing“.

EMOS spol. s r.o. declares that the LED PANEL SURFACE MOUNTED is in compliance with the essential requirements and other relevant provisions of Directive. The device can be freely operated in the EU. The Declaration of Conformity can be found at http://www.emos.eu/download.

Do not dispose with domestic waste. Use special collection points for sorted waste. Contact local authorities for information about collection points. If the electronic devices would be disposed on landfill, dangerous substances may reach groundwater and subsequently food chain, where it could affect human health.

ZM5171 | ZM5172 | ZM5173

This product contains a light source of energy efficiency class F

ZM5181 | ZM5182 | ZM5183

This product contains a light source of energy efficiency class G