Jiabei JB-WXC20 High Penetration Long Distance Wireless Charger User Manual

May 15, 2024
Jiabei

Jiabei JB-WXC20 High Penetration Long Distance Wireless Charger

Jiabei-JB-WXC20-High-penetration-Long-Distance-Wireless-Charger-
product

Parameters

Jiabei-JB-WXC20-High-penetration-Long-Distance-Wireless-Charger-fig-
\(1\)

Installation

Please ensure that the desktop is made of non-metallic material and the thickness does not exceed the maximum distance that the product can charge.

  1. Connect adapter: Please connect the included adapter to power up the wireless charger.Jiabei-JB-WXC20-High-penetration-Long-Distance-Wireless-Charger-fig- \(2\)
  2. Stick charging area label: Determine the charging area, align it with the position, and stick the charging area label.
  3. Ensure that there is no metal medium on the desktop and no metal crossbeam under the desk.
    Attention: If it is a glass or marble table, a 3M adhesive fixation method can be selected. If it is a wooden table, you can choose to fix it with screws.Jiabei-JB-WXC20-High-penetration-Long-Distance-Wireless-Charger-fig-
\(5\)

Adhesive wireless charging

  1. 3M adhesive fixation method: First, apply 3M adhesive to the surface of the wireless charging product, align the wireless charging with the charging area on the desktop, remove the 3M adhesive sticker on top of the wireless charging, and stick the wireless charging under the table.
  2. Screw fixation method: Align the wireless charger with the charging area of the desktop, and fix the wireless charger with screws under the table.Jiabei-JB-WXC20-High-penetration-Long-Distance-Wireless-Charger-fig- \(7\)
  3. Place the phone in the centre of the wireless charging area and display charging ready for use.

Attention

  • Do not disassemble the device without permission.
  • The effective charging distance of the charger is 5-30mm. Do not place the phone directly on the charger as this will trigger the foreign object detection function of the charger.
  • Do not place metal debris or magnetic cards on the wireless charging sticker as it may cause damage or the charger may not function.
  • If you encounter overheating in the receiving coil or transmitting board during use and stop charging, please remove the charging device and try again after it cools down.
  • Ensure that the phone has a wireless charging function.
  • Do not use or store the wireless charger in high-temperature or humid environments.

Indicator light status

  • Power on – the traffic lights flash quickly for 2 seconds and then turn off.
  • Standby mode – The indicator light is off.
  • Charging – the red light is constantly on.
  • Fully charged – If the charging device is fully charged, it will issue a charging completion signal and the green light will be on.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Warning
changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

Add: No. 2, Jidong Er yixiao Street, Xiaolan Town
Zhongshan City
Tel: 13802664499
0760-22261806

Site: www.jiabei888.com
Q Q : 308021056
Email: zsjiabei888@163.com

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals