SJE RHOMBUS Xpert Alert RF Alarm System Installation Guide
- June 9, 2024
- SJE RHOMBUS
Table of Contents
Expert Alert RF Alarm System
Installation Guide
Expert Alert® RF Alarm System
Installation Instructions 1069212A 3/2022
Expert Alert RF Alarm System
SJE RHOMBUS
FIVE-YEAR LIMITED WARRANTY
Five-Year Limited Warranty.
For complete terms and conditions, please visit
www.sjerhombus.com.
Operation / Features
Use this product only with the USB power supply provided.
Electrical Warnings /
Failure to follow these precautions could result in serious injury or death. Replace the float switch immediately if cable becomes damaged or severed. Keep these instructions with warranty after installation. This product must be installed in accordance with National Electric Code, ANSI/NFPA 70 so as to prevent moisture from entering or accumulating within boxes, conduit bodies, fittings, float housing, or cable.
WARNING| ELECTRICAL SHOCK HAZARD
Disconnect power before installing or servicing this product. A qualifi ed
service person must install and service this product according to applicable
electrical and plumbing codes.| WARNING| EXPLOSION OR FIRE HAZARD
Do not use this product with fl ammable liquids.
Do not install in hazardous locations as defined
by National Electrical Code, ANSI/NFPA 70.
---|---|---|---
Included with alarm
Specifications
Alarm Power:
USB Adapter:| 5VDC, 200mA Max
Input Voltage: 100-240VAC, 50/60Hz
Output Voltage: 5VDC, 1A. Micro USB
---|---
Enclosure:| Type 1 indoor
Panel Module Power:| 120VAC, 60Hz
Wire Harness:| 24 inches, 18 gauge
Panel Installation
4X Installation
Remove Expert Alert® alarm cover. Insert alarm module into the USB port. Mount alarm (indoor only) using keyhole on the back of the unit.
Replace cover and connect USB power cable.
Test alarm weekly to insure proper operation.
Refer to operation guide for start up.
Step 1: Installation
Mount and wire the alarm according to the installation instructions.
*Maximum distance between modules should be 200ft.
Step 2: Signal Strength Check
Press pairing but- ton for 1 second on the panel module to enter setup mode
for fast signal strength updates.
Reposition the indoor module until 1 or more signal LEDs are illuminated
green.
Step 3: Test Alarm
Verify the alarm is functioning by triggering an alarm condition on the
outdoor panel and verify the
indoor Expert Alert® alarm is alarming. Alarm LED on Expert Alert® RF and
Expert Alert® alarms will illuminate amber in color when alarming and the
audible alarm will sound. For Expert Alert® WiFi cation of alarm was
received.
Monthly Testing**
Verify at least 1 or more signal LEDs are illuminated green monthly , and
repeat step 3 as you are able.
Technical support: +1-800-746-6287
techsupport@sjeinc.com
www.sjerhombus.com
Technical Support Hours: Monday – Friday, 7 A.M. to 6 P.M. Central Time
1069212 REV A 3/2022 © 2022 SJE, Inc.
All Rights Reserved. SJE RHOMBUS is a trademark of SJE, Inc.