QW-756 Stewart Filmscreen Wall Switch Control Instruction Manual

QW-756 Stewart Film screen Wall Switch Control
Instruction Manual

QW-756 Stewart Filmscreen Wall Switch Control

Document Identifier| Revision| Date Approved| Date Effective
---|---|---|---
QW-756| A| 2/1/22| 2/2/22
Responsibility and authority:| Process Owner| Position/Title
Dino von Noy| QA Manager

PURPOSE:

To Safely and correctly Install High Voltage Wall Switch Control onto film screens.

Scope:

This procedure applies to Installing a 120 vAC high Voltage Switch.

Definitions:

120 vAC – 120 Volts Alternate Current

Reference Documents, Disclaimer:

Attention: All electrical connections must conform to local and NEC codes. Stewart Film screen cannot be held liable for faulty or sub-standard wiring.

Procedures:

Installing the high voltage wall switch control:
A standard 3-position 120 vAC wall switch is supplied. The high-voltage control is connected to the electrical source. It alternates direction of the screen motion by means of the hot leads, using the 3-postion switch.

1. Preparing the connection
   Before making the electrical connections, you need:
   An available 120 vAC constant power source.
   A 4-conductor Romex or motor connector cable

2. Making the connections

The wiring diagram illustrates the connections

1. Connect the wall switch to the 120 vAC constant power source.
2. Connect the wall switch to the screen unit’s motor leads.

Wiring diagram
SFC H.V. Latched Rocker Switch Single Pole Double Throw – SPDT

Quality Records:

The Reference for Stunning ™

Documents / Resources

| Stewart FILMSCREEN QW-756 Stewart Filmscreen Wall Switch Control [pdf] Instruction Manual
QW-756 Stewart Filmscreen Wall Switch Control, QW-756, Stewart Filmscreen Wall Switch Control, Stewart Filmscreen Wall Switch, Wall Switch Control, Filmscreen Wall Switch, Filmscreen, Wall Switch
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>