Stewart FILMSCREEN QW-757 Virtual Cockpit Installation Guide

June 9, 2024
Stewart FILMSCREEN

QW-757 Virtual Cockpit
Installation GuideStewart FILMSCREEN QW-757 Virtual
Cockpit STEWART FILMSCREEN CORPORATION
STEWART FILMSCREEN – Installing IMC

Document Identifier Revision Date Approved Date Effective
QW-757 A 2/2/22 2/3/22
Responsibility and authority: Process Owner Position / Title
Dino von Noy QA Manager

PURPOSE:

To Safely and correctly Install IMC Low Voltage Screen Control

Scope:

This procedure applies to understanding the IMC.

Definitions:

120 VDC – 120 Volts Direct Current

Reference Documents, Disclaimer:

Attention: All electrical connections must conform to local and NEC codes. Stewart Filmscreen cannot be held liable for faulty or sub-standard wiring.

Procedures:

The IMC is a low voltage screen control that allows for switching conductors to be run in Class II (small wire, exposed, no conduit) and will interface with outboard video switching systems. The IMC has the capability of being operated through a wall switch, infrared remote, radio frequency remote, internet protocol (IP) control system, and a screen trigger through a projector. For a detailed look at what the IMC has on board, please see page 2.
The IMC has the capability of being operated through a wall switch, infrared remote, remote, internet protocol (IP) control system (requires optional e-Node), Serial RS 232, (requires optional IBT-100) and a screen trigger through a projector.
The IMC comes prewired from the factory to the motor and to the power cable. For your reference, in the case of servicing, we broke down the pin layout for the high voltage side of the connections Always have a qualified electrician handle high voltage connections.

AC load side IMC 100 Motor Power Connections
BLACK Pin 1 AC Line +
WHITE Pin 2 AC Neutral
NC Pin3 Motor BLACK Line
NC Pin 4 Motor Neutral
GREEN Pin 5 Connect Ground to “Grounding” lug on IMC housing. Also connect

ground wire from motor housingto same lug

Stewart FILMSCREEN QW-757 Virtual Cockpit - voltage
connections

IMC Control Board Schematic

LVC Contacts IMC 100 COMMANDS
COMMON Pin 1 COMMON
CHANNEL 1 INPUT Pin 2 UP
CHANNEL 2 INPUT Pin 3 DOWN
SCREEN TRIGGER INPUT Pin 4 TRIGGER 3-15 VDC w/ COMMON

IMC Wiring DiagramStewart FILMSCREEN QW-757 Virtual Cockpit - IMC
Wiring Diagram Luxus G2
StewStewart FILMSCREEN QW-757 Virtual Cockpit - IMC Wiring Diagram 1art
FILMSCREEN QW-757 Virtual Cockpit - IMC Wiring Diagram 1 IMC with e-Node Stewart FILMSCREEN QW-757 Virtual
Cockpit - IMC Wiring Diagram 2 220V

Stewart FILMSCREEN QW-757 Virtual Cockpit - IMC Wiring Diagram
3

www.stewartfilmscreen.com
1161 W. Sepulveda Blvd., Torrance CA 90502
USA l 800.762.4999
Tel: 310.784.5300
Fax: 310.326.6870
Email: request@stewartfilmscreen.com
©2019 Stewart Filmscreen.
Specifications are subject to change without notice.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Stewart FILMSCREEN User Manuals

Related Manuals