ET2 Contemporary Lighting E24080-NAB Tether LED 1 Light Wall Sconce Instruction Manual
- June 9, 2024
- ET2 Contemporary Lighting
Table of Contents
E24080-NAB Tether LED 1 Light Wall Sconce
Instruction Manual
E24080-NAB Tether LED 1 Light Wall Sconce
LAMPING: LED Integrated 15W
Vinput: 120-277V
MADE IN CHINA
LED Lighting (LOW VOLTAGE)
Before Getting Started
Read the instructions carefully prior to assemblies product.
When you open the package with a sharp tool like a cutter knife, be careful
not to damage the components inside.
Carefully remove all packaging materials and retain for future use.
Keep all hardware parts and packaging out of reach of small children.
Choose a clean, level, spacious assembly area.
Avoid hard surfaces that may damage the product.
Ensure that you have all required contents for complete assembly.
Take care when lifting. Assemble the product i close proximity to where you
intend to position the item.
Do not over tighten the screws and bolts as this may damage the threads.
Do not let children play with this product.
- Risk of suffocation!
Keep any packaging materials away from children.
Low Voltage LED Lighting Instructions
Carefully read through the instruction sheet before assembly and using the
product.
Caution there is a risk of shock. Disconnect from power source before
assembling or cleaning.
WARNING: Wires need to be connected to driver found in canopy and should
not be connected directly to power source or a short may occur.
Do not cut factory connections unless instructed by the manufacturer
Do not plug the product in if cord is torn or frayed.
Cleaning & Maintenance
On polished finishes, often using talc powder reduces the appearance of
fingerprints and other smudges.
For respective shade surfaces, use the appropriate cleansers, i.e. glass
cleaner, acrylic polish, and wood polish. Clean with soft cloth and a mild
detergent. DO not use abrasive cleaner.
Periodically (every 90 days) make sure that the screws are fully tightened.
Prolonged exposure to heat sources may cause glazing, melting and scorching,
or even cause color to fade.
Before getting, started, ensure the package contains the following components.
|
---|---
DIMMING COMPATIBILITY
WIRING DIAGRAM (ONLY FOR REFERENCE)
DO NOT ATTEMPT TO CUT FACTORY CONNECTIONS WITHOUT QUALIFIED KNOWLEDGE.
MODIFICATIONS
MADE TO THIS PRODUCT WITHOUT THE CONSENT OF THE MANUFACTURER WILL VOID
WARRANTY.
schematic for general reference only
THIS FIXTURE HAS BEEN TESTED TO DIM WITH . . .
0-10V Dimming System*
Lutron Diva CL Triac
Lutron Diva ELV
Must be installed by a electrician with knowledge of electronic light
system
©2022 MAXIM LIGHTING GROUP
Documents / Resources
| ET2
Contemporary Lighting E24080-NAB Tether LED 1 Light Wall
Sconce
[pdf] Instruction Manual
E24080-NAB, E24080-NAB Tether LED 1 Light Wall Sconce, E24080-NAB 1 Light Wall
Sconce, Tether LED 1 Light Wall Sconce, 1 Light Wall Sconce, Wall Sconce
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>