Hansgrohe 74802XXX Zesis M33 150 Kitchen Faucet Instruction Manual
- June 9, 2024
- hansgrohe
Table of Contents
Hansgrohe 74802XXX Zesis M33 150 Kitchen Faucet
Safety Notes
- Gloves should be worn during installation to prevent crushing and cutting injuries.
- The hot and cold supplies must be of equal pressures
Installation Instructions
- Prior to installation, inspect the product for transport damages. After it has been installed, no transport or surface damage will be honoured.
- The pipes and the fixture must be installed, flushed and tested as per the applicable standards.
- The plumbing codes applicable in the respective countries must be observed.
- 74807000, 74808000: Only dishwashers and washing machines certified with the DVGW emblem may be connected to the appliance connection valve without an additional fuse. If no consumer is connected to the appliance connection valve, it must be plugged.
Technical Data
- Operating pressure : max. 1 MPa
- Recommended operating pressure: 0,1 – 0,5 MPa
- Test pressure : 1,6 MPa (1 MPa = 10 bar = 147 PSI)
- Hot water temperature : max. 60°C
- Thermal disinfection: 70°C / 4 min
description
Do not use silicone containing acetic acid!Adjustment (see page 38) To adjust the hot water limiter. Using a hot water limiter in combination with a continuous flow water heater is not recommended.
Dimensions
Flow diagram
Spare parts
- XXX = Colors
- 000 = Chrome Plated
- 670 = Matt Black
- 800 = Stainless Steel Optic
Special accessories
(order as an extra)
- Adapter (G⅜ / G½) #93395000
- Cleaning
- Operation
- Hansgrohe recommends not to use as drinking water the first half liter of water drawn in the morning or after a prolonged period of non-use.
- After periods of prolonged non-use, but at least every third day, the fittings must be opened with the handle in hot and cold position to prevent stagnation in the connecting lines. Let the water run until the water temperature is constant.
- Test certificate
TROUBLESHOOTING
| Fault | Cause | Remedy |
|---|---|---|
| Insufficient water | – Aerator calcified, dirty | – Clean aerator, replace as |
necessary
Mixer stiff| – Cartridge defective, calcified| – Exchange cartridge
Mixer dripping| – Cartridge defective| – Exchange cartridge
Water escaping in area of swivel
spout
| – O-ring defective| – Exchange O-ring
Water escaping at the threaded base| – O-ring at the connection hose
defective.
| – Exchange O-ring
Hot water temperature too low| – Hot water limiter incorrectly set| – Set hot
water limiter
Hansgrohe · Auestraße 5 – 9 · D-77761 Schiltach
- Telefon +49 (0) 78 36/51-1282
- Telefax +49 (0) 7836/511440
- E-Mail : info@hansgrohe.com
- Internet : www.hansgrohe.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>