LEVOLOR 15-Channel InMotion Remote User Guide
- June 9, 2024
- LEVOLOR
Table of Contents
InMotion™
Remote
Top-Down/ Bottom-Up Day/Night
Quick Start Guide
15-Channel InMotion Remote
The LEVOLOR ® InMotion ™ Remote achieves effortless light control at the
touch of a button.
Pair your remote before installing window coverings
- Use the – and + buttons to select the channel.
- Press and hold the programming button on the window covering for about 2 seconds until the shade jogs and/or beeps once.
- In the next 10 seconds, press and hold the □ stop button on the remote until the shade jogs twice and/or beeps three times.
Visit levolor.com/InMotionSupport or use the QR code to download the complete remote guide.
Thank you for choosing LEVOLOR ® InMotion ™ .
U.S Radio Frequency FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interfer- ence to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Any changes or
modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on acircuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Industry Canada
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the
equivalent isotopically radiated power (e.i.r.p.) is not more than that
necessary for successful communication. This device complies with Industry
Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions. (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that
may cause undesired operation. Class B Digital Device Notice This Class B
digital apparatus complies with Canadian ICES-003, RSS-Gen and RSS-210.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>