Simply 6.5 Inch Slim Flush Mount With PIR Sensor Installation Guide
- June 9, 2024
- Simply
Table of Contents
3WAY CCT Adjustable PIR Slim Flush Mount ( Round Panel )
www.simplyretrofits.com
Installation Guide
IMPORTANT SAFETY INFORMATION
- WARNING : RISK OF SHOCK House electric current can cause painful shock or serious injury unless handled properly. For your safety, always remember to : A : Turn off the power supply at the fuse or circuit breaker box before you install the fixture. B: Ground the fixture to avoid potential electric shocks and to ensure reliable starting. C: Double-check all connections to be sure they are tight and correct. D : Wear rubber soled shoes and work on a sturdy wooden ladder.
- This fixture is designed for use in a circuit protected by a fuse or circuit breaker. It is also designed to be installed in accordance with local electrical codes. If you are unsure about your wiring, consult a qualified electrician or local electrical inspector, and check your local electrical code.
- WARNING : RISK OF CUTS Some metal parts in the fixture may have sharp edges. To prevent cuts and scrapes, wear gloves when handling the parts.
- Account for small pans and destroy packing material, as these may be hazardous to children.
Product Specification
| Onn4 | Pater | Lumens (Im) | Input Voltage | Dimmable |
|---|---|---|---|---|
| 165x2Omm | 12W | 9601+-10% | AC120V | No |
| 227x20mm | 18W | 144+-10% | AC120V | No |
Embeded in installation
Suface mounting intallation
How to uninstall
Day and Night Sensor Function
Daylight sensor Switch
Choose Day or Night mode via the switch located on the fixture body.
- Daytime’
- Nighttime
Sensor diagram
Caution
- WARNING : Risk of fire. Use AC 120 50/60HZz circuss.
- Suitable for dame locations. Belore instaling your lighting fixture, thoroughly review enclosed installation manual. If you do not have sufficient &-ectical wiring experience, please refer to a do-tt-yoursell wiring handbook or have your fixture installed by a qualified licensed electrician. All electrical connections must be in a accordance with local and National Electrical Code(NEC) standards. Reliable operating temperature is -20 to +40 degrees Celsius(-4 to +104 degrees Fahrenhet).
- pis obey fire prevention regulations, do not cover the fixture with any heat insulated materiais.
- Do not change the LED light source or driver inside under any circumstance.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>