Hansshow 3 2022 AMD SR DIY Audio Upgrade|SR Speaker Instruction Manual

: June 9, 2024
: Hansshow

Table of Contents

Warm Prompt
Installation steps
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Hansshow 3 2022 AMD SR DIY Audio Upgrade|SR Speaker

3 2022 AMD SR DIY Audio UpgradeSR Speaker

Note:

The installation instructions may differ slightly from the actual operation. If there are any differences, please follow the actual situation or contact us.
Warning: Please do not disassemble any part by yourself, any improper operation will not be covered by our warranty.

Warm Prompt

If the vehicle is found to have inoperable fault or other serious fault, pls contact Tesla’s after-sales department for maintenance.

In order to avoid Tesla blaming the problems on the installed products, please remove the products first, and then go to Tesla’s after-sales department for maintenance.

Otherwise, if not remove the products, Tesla will charge maintenance fees, which shall be borne by yourself.
Warm Prompt

Note : Before installing the product, please do the following steps:

Tum off the power on Tesla screen;
Disconnect the negative pole of 12V power supply at the frunk;
Finally, disconnect the high-voltage gray plug under the right side of the rear seat. Otherwise, it will cause window lifting fault, door fault, or screen fault code.

Installation steps

Before installing the product, please tum off the power supply on the screen first, then disconnect the gray DCDC plug under the right rear seat, and then disconnect the negative pole of the battery in the frrunk. Otherwise, it will cause window lifting fault, door fault, or screen fault code.

Turn off the host power in the vehicle setting.
Remove the negative pole of the small battery on the Frunk
Open the rear seat cushion and unplug the power plug

The red line refers to the wiring harness routing position. See the schematic diagram for details
The red line is the wiring harness routing position
First remove the screws and buckles from the guard board on the front passenger foot socket, and then remove the guard board
Remove the knee pad at the front passenger position, connect the black plug to plug ③
On the right side of the foot socket under the A-pillar of the front right seat, find the main plug of the right door and connect it to No plug ⑤
Find the blue plug on the right door B-pillar safety belt fixing limit trim panel and transfer the blue plug with plug ④