Hansshow 3/Y Dashboard Hidden HUD Installation Guide
- October 30, 2023
- Hansshow
Table of Contents
Hansshow 3/Y Dashboard Hidden HUD
Note
- The installation instructions may differ slightly from the actual operation. If there are any differences,please follow the actual situation or contact us.
- Warning: Please do not disassemble any part by yourself, any improper operation will not be covered by our warranty.
- Before installing the product, watch the installation video and manual carefully.
- Before installing the product, please turn off the vehicle power and cut off the negative electrode of the frunk battery.
Aftersale Contact:
phone/whatsapp : +86 130 4421 9654 Email:
support@hansshow.com
Working Hours (UTC+8):
9:00AM – 18:30PM (Monday to Sunday) Please leave a message at other times
Product List
Installation Steps
- Schematic diagram of harness routing position.
- Turn off the host power on the screen.
- First, insert the small HUD ① into the air outlet of the air conditioner in the middle of the steering wheel, and then hide the harness.
- Remove the trim panel cover with a pryboard; then route the harness according to the wiring diagram as shown on the picture
- Pry off side trim panel cover on the center console
- Route the harness to the back of the center console saddle
- Connect the plug ②
- Remove the trim panel cover on the back of center console
- Connect plug ③ with the b l u e p l u g o f t h e o r i g i n a l vehicle.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>