REED RCR3/4 Round It Straightener or Rerounder Instructions
- June 9, 2024
- REED
Table of Contents
**REED RCR3/4 Round It Straightener or Rerounder Instructions
**
Use only with “K” Copper
The tool straightens and rounds anywhere along the length of Type K copper tubing. Work hardening and age hardening of copper can degrade the performance of this tool. The degree of initial outof-roundness of tube can also degrade the toolʼs performance. Results may vary due to the above pre-existing conditions.
Rerounding
- Place the tool over the copper tube and push the handles together. Then, release.
- Rotate the tool 90º and push the handles together. Then, release.
- Repeat as needed.
Adjusting the tool
- Loosen the Lock Screw.
- Turn the Adjusting Screw clockwise to close the jaws. (Turn counterclockwise to open the jaws.)
- Tighten the Lock Screw. (Over tightening the Lock Screw will cause the handle to break in service.)
Contact Phone: 800-666-3691 or
+1-814-452-3691
reedsales@reedmfgco.com
www.reedmfgco.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>