HALCYON EX912 B34DC 2.5W Low Glare Wall Eyelid Select User Manual
- June 10, 2024
- HALCYON
Table of Contents
HALCYON EX912 B34DC 2.5W Low Glare Wall Eyelid Select
Product Information
The EX912 B34DC is a luminaire with a non-replaceable light source. It is designed for exterior use and requires periodic cleaning to protect the surface and/or coating from corrosion. The luminaire must be installed by a qualified Registered Electrician to prevent damage to the luminaire and maintain electrical safety. If the external flexible cable or cord of this luminaire is damaged, it must be exclusively replaced by the manufacturer or his service agent or a similar qualified person to avoid any hazard. The base plate, cable entry gland, and screw heads must be covered in silicone sealant to prevent luminaire failure from water ingress.
Product Usage Instructions
- Installation : The luminaire must be installed by a qualified Registered Electrician to ensure electrical safety and prevent damage to the luminaire.
- Replacing Damaged Cable : If the external flexible cable or cord of the luminaire is damaged, it must be exclusively replaced by the manufacturer or his service agent or a similar qualified person to avoid any hazard.
- Periodic Cleaning : The exterior of the luminaire requires periodic cleaning to protect the surface and/or coating from corrosion. Use warm soapy water and a soft brush with a neutral detergent. Do not use a water blaster or high-pressure hose, do not submerge fittings for extended periods of time.
- Replacing the Light Source : The light source of this luminaire is not replaceable; when the light source reaches its end of life, the whole luminaire shall be replaced.
- Preparing for Long Time Operation : To ensure long-time operation, please prepare an IP67 waterproof box containing an adequate driver to connect between the luminaire and power input.
- Switching Color Temperature: When switching the color temperature, make sure the power is off.
- Wood Board Thickness : When mounting the luminaire on a wood board, ensure that the thickness of the wood board is not less than 10mm.
- Cable Outlet : Keep the cable outlet in the same vertical direction with the inlet to luminaries to ensure proper installation.
INTRODUCTION
This luminaire must be installed by a qualified Registered Electrician to prevent damage to the luminaire and maintain electrical safety. If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Caution ,risk of electric shock
Base plate,cable entry gland and screw heads must be covered in silicone sealant. Failure to do so may cause luminaire failure from water ingress. All exterior luminaires (with the exception of copper) require periodic cleaning to protect the surface and/or coating from corrosion and ensure tidy appearance for the lifespan of the product. Wash with care using a soft brush and warm soapy water using a neutral detergent. Coastal areas require extra attention, especially fittings which are under eaves/soffits and do not have any exposure to rain. Do not use a water blaster or high pressure hose, do not submerge fittings for extended periods of time. 316 stainless steel fittings will still develop surface rust or “tea staining” if left uncared for.
SWITCH ON/OFF
INSTALLATION INSTRUCTIONS
Note : In order to reach the required IP, the input cable for the luminaries must be H05RN-F 2×1.0mm², and threading through before stripping
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>