HALCYON EX163 Surface Mount Column Spot Two Way Up-Down Large Instruction Manual
- June 10, 2024
- HALCYON
Table of Contents
HALCYON EX163 Surface Mount Column Spot Two Way Up-Down Large
PRODUCT INFORMATION
The product is a luminaire with the model number EX163. The luminaire is designed to provide lighting and is not replaceable. The luminaire has a base plate, cable entry gland, and screw heads that must be covered in silicone sealant to prevent water ingress. The luminaire requires installation by a qualified Registered Electrician to ensure electrical safety and prevent damage to the luminaire.
INTRODUCTION
This luminaire must be installed by a qualified Registered Electrician to
prevent damage to the luminaire and maintain electrical safety. If the
external flexible cable or cord of this luminaire is damaged, it shall be
exclusively replaced by the manufacturer or his service agent or a similar
qualified person in order to avoid a hazard.
The light source of this luminaire is not replaceable; when the light source
reaches its end of life the whole luminaire shall be replaced. Base
plate,cable entry gland and screw heads must be covered in silicone sealant.
Failure to do so may cause luminaire failure from water ingress.
All exterior luminaires (with the exception of copper) require periodic
cleaning to protect the surface and/or coating from corrosion and ensure tidy
appearance for the lifespan of the product. Wash with care using a soft brush
and warm soapy water using a neutral detergent. Coastal areas require extra
attention, especially fittings which are under eaves/soffits and do not have
any exposure to rain. Do not use a water blaster or high-pressure hose, do not
submerge fittings for extended periods of time. 316 stainless steel fittings
will still develop surface rust or “tea staining” if left uncared for.
PRODUCT USAGE INSTRUCTION
- Installation: The luminaire must be installed by a qualified Registered Electrician to ensure electrical safety and prevent damage to the luminaire. Choose the appropriate backstand and fix it using a tool of your choice. If installing on a concrete surface, use FIG-2-A and ensure that the side marked with “up” is at the top for the backstand. If installing on a wood board, use FIG-2-B and ensure that the thickness of the wood board is not less than 5mm. Cover the base plate, cable entry gland, and screw heads with silicone sealant to prevent water ingress.
- Replacement: If the external flexible cable or cord of the luminaire is damaged, it must be replaced exclusively by the manufacturer, their service agent, or a similar qualified person to prevent hazards. When the light source reaches its end of life, replace the whole luminaire.
- Electrical Connection: Connect the luminaire to a 220-240V power supply using the provided blue (N) and brown (L) wires. Ensure that the cable outlet is in the same vertical direction as the inlet to the luminaire.
- Switching: Use the ON/OFF switch labeled 1 and 2 to turn the luminaire on and off.
INSTALLATION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>