HALCYON LED502 W46XPMS LED IP65 Batten Light Instruction Manual
- June 10, 2024
- HALCYON
Table of Contents
HALCYON LED502 W46XPMS LED IP65 Batten Light
PRODUCT INFORMATION
- Product Name: LED IP65 Batten Light
- Model #: LED501 W46XPMS, LED502 W46XPMS
- Description: 36 Watt LED, Non-dimmable, IP65, 4000K I 6000K 45 Watt LED, Non-dimmable, IP65, 4000K I 6000K
- Rated Voltage: 220-240V~, 50/60Hz
INSTALLATION
- Switch off power.
- Install the bracket.
- Knock out the hole, fix the waterproof gland.
- Connect the power cords as show on the picture.
- Fasten the clips and drive the 2pcs screws.
- Tighten the waterproof gland.
- Install the fixture on ceiling.
- Switch luminaire on to test luminaire functions correctly and is electrically safe.
Installation note: Do not install on the same circuits as Metal halide,
Fluorescent and other “Low power factor” devices.
When installed on the same circuit it can cause flickering and/or premature
failure of the “high power factor” electronic drivers. The harmonic distortion
from low power factor devices alters the Waveform of the AC supply which can
cause componentry in high power factor electronic drivers to resonate, run
over temperature and fail after prolonged exposure.
REMOTE CONTROL SETTINGS
APPLICATION
Detection coverage
Typical installation height 2.5-6m. This figure indicates the maximum
distance at the highest mounting height with 100% sensitivity.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>