RFL AUDI A6 C5 Pre Facelift Car Instruction Manual
- June 10, 2024
- RFL
Table of Contents
AUDI A6 C5 Pre Facelift Car
Instruction Manual
| Parts needed | Tools needed |
|---|---|
| 2x Aharon TL-r projectors | 7mm socket |
| 2x Aharon H7 high beam splitter cables | PZ / PH screwdriver / bit |
| 2x Custom made brackets + mounting hardware | Coffee and a little bit of |
patience
Instructions
Disassemble the OEM projector
Disassemble the OEM projector and take it out of the headlight. For more info
about how to disassemble/remove the projectors, please scan the QR at the
bottom of this manual.
** Make sure to keep the locknuts. You need them in a later stage.
Mount the hardware
In order to mount the new projector and bracket you need to mount the included
hardware as followed. 
Mounting the projector
** Mount the bracket onto the threaded mounting points, positioned at the
bottom of the headlight. Use the M4 lock nuts, that were used to mount the OEM
projector, to secure the bracket.
Before you mount the projector make sure to connect the solenoid cable to the
connector on the bottom of the projector.
Mount the projector onto the threaded mounting points and use the M4 locking
nuts to secure the projector (solenoid motor must be positioned to the bottom
of the headlight) Note that it can be a bit hard to reach the threaded
mounting points when the projector is in place..
INSTALLATION INSTRUCTIONS
AUDI A6 C5 – pre facelift
Disassemble the OEM projector
Connect the supplied H7 splitter like shown on the picture:
- connect to h7 halogen high beam bulb
- connect to h7 high beam feed from headlight
- connect to solenoid cable of projector
Disassemble the OEM projector
Insert the D2S bulb, using the supplied bulb holder, and connect the D2S
igniter to the bulb. Close the lid and you’re done 🙂
Need help?
https://www.youtube.com/watch?v=L5DjK9jlkgI&ab_channel=Retrofitlab.com
For more info about opening the headlight and how to remove the OEM projector please scan the QR-code.