RFL H4 Motorcycle Led Wire Harness Instructions
- June 10, 2024
- RFL
Table of Contents
RFL H4 Motorcycle Led Wire Harness
Product Information
Motorcycle LED H4 Wire Harness
The Motorcycle LED H4 Wire Harness is a wiring harness designed to connect the H4 headlight feed, driver of LED projector, 12v+ source of battery, and high beam connector of LED projector. The wire harness comes with five pins that are numbered for easy identification during installation. It is important to note that when using this H4 wire harness with a time delay relay, some motorcycles may experience electrical problems such as the motorcycle not shutting off. In such cases, it is recommended to remove the middle pin from the relay to fix the problem.
Product Usage Instructions
- Connect pin 1 to the H4 headlight feed.
- Connect pin 2 to the driver of LED projector.
- Connect pin 3 to the 12v+ source of battery.
- Connect pin 4 to the high beam connector of LED projector.
- Connect pin 5 to ground/chassis of bike.
Ensure that all connections are secure and properly fitted. If using a time delay relay, check for any electrical problems such as the motorcycle not shutting off. If such problems occur, remove the middle pin from the relay to fix the issue.
For more information and support, please visit: www.retrofitlab.com
INSTALLATION INSTRUCTIONS
- CONNECT TO H4 HEADLIGHT FEED
- CONNECT TO DRIVER OF LED PROJECTOR
- CONNECT TO 12v+ SOURCE OF BATTERY
- CONNECT TO GROUND/CHASSIS OF BIKE
- CONNECT TO HIGH BEAM CONNECTOR OF LED PROJECTOR
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>