HALCYON R677 Smart Tilt Classic Installation Guide
- June 10, 2024
- HALCYON
Table of Contents
HALCYON R677 Smart Tilt Classic
Installation Directions
-
Switch off mains power supply
-
Connect Dimmable Driver to mains voltage cable (L, N) Do not connect the downlight to the driver if driver is live.
Inrush current from live driver will cause instant downlight failure. Do not switch the secondary side. -
Carefully install downlight into Pre-cut 82-84mm hole.
-
Turn on mains power and switch on lighting circuit.
Approved Clearances
Note: Omm required but 25mm always recommended for optimum product lifespan through effective heat dissipation.
Example 1:
Omm Approved Height Clearance. Building element abutting rear, insulation
abutting sides of fitting.
Example 2:
Omm Approved Side Clearance. Building element abutting side of fitting,
insulation abutting and covering fitting.
Driver is designed to be covered and abutted with IC I IC-F approved insulation.
CLASSIFICATION SHEET 1 •C
Classification| | IC – building insulation that can safely be
continuously exposed to 90°C allowed to abut and cover the luminaire.
---|---|---
In the vicinity of the recessed luminaire, use an insulation product that:
- Maintains its dimensions and structural integrity when exposed to a temperature of 900C; and
- Withstands a 30-second needle flame test carried out in accordance with AS/NZS 60695. II .5 with the flame applied to all surfaces of the sample.
Rear of fitting may abut structural members and building elements.
Do not install through or directly into joist, beam, rafter or ceiling batten.
Recessed
luminaires and their associated equipment may pose a risk of fire or damage to
property if not installed and maintained correctly. Halcyon recommends a
clearance of 25mm to building elements for optimum lifespan.
Halcyon IC rated luminaires are completely safe to install in sarked timber
ceiling linings.
Halcyon accepts no responsibility if the timber used is not treated correctly
and dries out, crack or warps over time due to the constant low heat from the
aforementioned “IC Rated” LED recessed lighting.
This data sheet contains information necessary to ensure compliance with the
New Zealand Electrical Code of Practice for Installation and Maintenance of
Recessed Luminaires and Associated Equipment ASINZS 60598.2.2:2001
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>