Voda VST21 Storm Wall Mounted Basin Mixer User Manual
- June 10, 2024
- voda
Table of Contents
Voda VST21 Storm Wall Mounted Basin Mixer
STORM
Wall Mounted Basin Mixer
VST21
Congratulations on your purchase of this high quality product from Voda Plumbing ware. Please read the following before installation and retain (along with your receipt) for future reference.
TECHNICAL SPECIFICATIONS
Suitable for All Pressures
Minimum Pressure = 35kPa
Maximum operating Pressure = 500kPa* (As per NZ Building Code AS/NZ 3500.1)
Maximum operating Temperature = 65 deg. Celsius For domestic use only.
CONFIGURATION
| Mains Pressure systems | Install mixer and spout as supplied. |
|---|---|
| Unequal Low systems | Insert Green Non-Return valve into Hot inlet port (marked |
with H), and Yellow Flow Restrictor into Cold inlet port (marked with C). Note
direction of flow arrows on side of inserts, install with black O-ring to
outside on yellow insert, and white o-ring to outside on green insert. Change
the aerator to the Low Pressure flow straightener supplied in the box.
Equal Low systems| Install mixer as supplied. Change the aerator to the Low
Pressure flow straightener supplied in the box.
INSTALLATION
*FOR PRESSURES EXCEEDING 500kPa INSTALL A PRESSURE REDUCING VALVE. THOROUGHLY FLUSH ALL PIPES TO ELIMINATE ANY REMAINING DIRT AND RESIDUE, AND INSTALL INLINE FILTERS. FAILURE TO DO SO MAY VOID THE WARRANTY.
- SEE DIAGRAM OVERLEAF.
- Flush all water lines to remove any foreign materials so it does not interfere with the flow regulated aerator or damage the ceramic cartridge.
- Make sure that the body recess including wall lining thickness allows wingback to fit flush with wall lining (approx 37mm).
- Note the protrusions at the back of the body to ensure a perpendicular mounting once screwed into place.
- Note when installing breech pipe the different tail lengths. The longer tail length should be fitted into the wingback, with shorter tail into mixer body.
Note different tail lengths on breech pipe.
**IMPORTANT: This mixer and spout are fitted with 80mm faceplates.
Maximum hole dimension in finished wall lining should not exceed 50mm.
Seal with silicon if required
- The three piece mixer-wingback-breech pipe design allows for different spout/mixer configurations to suit different bathroom designs. The mixer can be installed on the left or right hand side of the spout, and with the mixer handle either pointing up or down.
- Copper olives and brass nuts are supplied, ensure the use of adequate hemp and graphite, or PTFE tape to ensure a water tight fit as per good plumbing practice.
- After screwing spout to wingback, spout can be adjusted to final positioning by loosening small grub screw underneath spout and aligning.
- Turn on mains supply.
- Check for leaks.
Plumbers Note: Do not pressure test this mixer under static pressure.
WARRANTY
PLEASE CALL US BEFORE REMOVING TAPWARE OR UNDERTAKING ANY REPAIR WORK.
Please refer to our website for full warranty information: www.vodaplumbingware.co.nz/warranty
In the unlikely event that this product fails during its warranty period, phone our Customer Service team immediately on 0508 367 366 – as unauthorised removal of the product may void the warranty.
CARE AND MAINTENANCE
SHOULD NOT BE CLEANED WITH ACIDIC, CAUSTIC/ALKALINE, ABRASIVE OR CITRIC
CLEANERS.
A soft, damp cloth is recommended for cleaning. Mild soap solutions can also
be used on occasion
PROUD PARTNER AND SUPPORTER OF MASTER PLUMBERS, GASFITTERS AND DRAINLAYERS
CUSTOMER SUPPORT
Voda Plumbingware Limited | Freephone: 0508 367 366 | 5 Hewlett Street, Port Whangarei 0110 | vodaplumbingware.co.nz
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>