voda plumbingware VSS023 STAINLESS Basin Mixer Instruction Manual
- June 2, 2024
- voda plumbingware
Table of Contents
voda plumbingware VSS023 STAINLESS Basin Mixer Instruction Manual
Congratulations on your purchase of this high quality product from Voda
Plumbingware.
Please read the following before installation and retain (along with your
receipt) for future reference.
TECHNICAL SPECIFICATIONS
Suitable for All Pressures
Minimum Pressure = 35kPa
Maximum operating Pressure = 500kPa*
Maximum operating Temperature = 65 deg. Celsius
For domestic use only.
CONFIGURATION
Mains Pressure systems Remove the flow restrictor from the nut of the cold
hose and change aerator to the Mains Pressure one (supplied).
Unequal Low systems Install as supplied.
Equal Low systems Prior to installation, remove the flow restrictor from the
nut of the cold hose.
INSTALLATION
*FOR PRESSURES EXCEEDING 500kPa INSTALL A PRESSURE REDUCING VALVE.
THOROUGHLY FLUSH ALL
PIPES TO ELIMINATE ANY REMAINING DIRT AND RESIDUE, AND INSTALL INLINE
FILTERS. FAILURE TO DO SO MAY VOID THE WARRANTY.
-
Before commencing installation turn off the water supply.
-
Position tap in 35mm hole, making sure the seal between tap and supporting surface is in place.
-
Anchor to bench with fittings pack.
-
Thoroughly flush all pipes to eliminate any remaining dirt and residue and install inline filters.
-
Connect supply hoses to plumbing connections. Minimum bend for flexible hose is 35mm radius.
Do not stretch, crush or twist hoses. Do not swage hose ends. -
Turn on mains supply.
-
Check for leaks.
-
PLUMBERS NOTE: DO NOT PRESSURE TEST THIS MIXER UNDER STATIC PRESSURE.
WARRANTY
PLEASE CALL US BEFORE REMOVING TAPWARE OR UNDERTAKING ANY REPAIR WORK.
Please refer to our website for warranty information: www.vodaplumbingware.co.nz/warranty
In the unlikely event that this product fails during its warranty period, phone our Customer Service team immediately on 0508 367 366 – as unauthorised removal of the product may void the warranty.
CARE AND MAINTENANCE
NOT TO BE CLEANED WITH ASTRINGENT, ABRASIVE OR CITRIC CLEANERS.
A soft, damp cloth is recommended for cleaning. Mild soap solutions can also be used on occasion.
Try to avoid excessive scrubbing as this could cause damage and void your warranty.
Voda Plumbingware Limited | Freephone: 0508 367 366 | 5 Hewlett Street, Port Whangarei 0110 | vodaplumbingware.co.nz