COLOR WAV 2A7SG Sound Bar Instruction Manual
- June 10, 2024
- COLOR WAV
Table of Contents
2A7SG Sound Bar
Instruction Manual
TECH SPECS:
| Input voltage | 5V |
|---|---|
| Output Power | SW x2 |
| Audio input (PC) | Wireless, TF, USB |
| Battery | 2000 mAh |
| Frequency range | 35Hz-16kHz |
| Dimensions (L x W x H) | 15 x 2.5 x 2.5 IN |
| Weight | 0.9 lbs |
CONNECTING A WIRELESS DEVICE:
Power the speaker on using the ON/OFF switch
On your device’s wireless connection menu, find and select the device
“ColorWav”
The blue LED on top of the speaker will flash while waiting to connect
Once connected you will hear “paired” and the blue LED on top of the speaker
will remain illuminated
When the battery is low, the speaker will indicate by saying, “low battery”
CHARGING THE COLOR WAV SPEAKER:
Ensure the speaker is fully charged before first use
Plug the included charging cable into the charging port of the speaker and
connect the USB-A end of the cable into a compatible power source
A red LED light by the charging port will illuminate, indicating the speaker
is charging
When the device indicates the battery is low, approx. 4-5 hours of charging
time is needed to fully recharge the battery
SAFETY INFORMATION:
Do not attempt to disassemble, repair, or modify this device
Do not expose the speaker to extreme temperatures
The speaker may become warm while charging, this is normal
Do not expose the speaker to water or humidity
BUTTON FUNCTIONS:
- PLAY/PAUSE
- SHORT PRESS TO PLAY PREVIOUS SONG LONG PRESS TO LOWER THE VOLUME
- SHORT PRESS TO PLAY NEXT SONG LONG PRESS TO RAISE THE VOLUME
- PRESS TO SWITCH THE RGB LIGHT MODE
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. FCC Caution: Any
changes or modifications not expressly approved by the party responsible for
compliance could void the users authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful Interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful Interference to radio communications. However,
there Is no guarantee that Interference will not occur in a particular
Installation. If this equipment does cause harmful Interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the Interference by one or more
of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>