Positioning Universal TM90 Asset Tracker User Manual

Positioning Universal TM90 Asset Tracker

 ID and Tooling Design

Dimensions: 92mm50mm18mm
Weight: g (with optional battery)

Physical and Electrical Specifications

• Input Voltage: 7-36VDC
• Power consumption:
  •  Active mode: 1 00mA @12VDC
  •  Sleep mode: <5mA @12VDC
• Operating temperature: -30°C to 80°
• Storage temperature: -30°Cto 80°C

Input/Output

Download and debug port: 1
SWDlnterface: 1
Function LEDs: 2
GPS Status Green
Cellular StatusOrange
Buzzer:1
lnput:1
Output:1

Cellular Communication

Operation mode: LTE/GPS
Operation band : LTEB2/B4/B12/B13/B25;GPS 1.57542GHz
Modulation: QPSK/16QAM

 Harnesses

There are 1 harness that may be used with the TM90M-4: 4 wire power and 1/0 harness

Event Codes

The table below relates the Event codes in the message to the reason the message was generated:

System network structure

GPS alarm is currently the most advanced security Setting. GPS alarms are more expensive than ordinary burglar alarms and need to pay an additional service fee, so their popularity i s not high. And the alarm is based on a GPRS network communication network, combined with the intelligent linkage of mobile phone and car anti-theft, this kind of alarm is not restricted by distance, the overlay network is wide, but need to pay the monthly rental. Buying guide to edit GPS alarm when the choose and buy, need to pay attention to is the comparison of several common GPS performances.

Introduction

This chapter is user manual for TM90M.

List

1. three TM90M devices.
2. One DC 12V cable.

Description

Connect the DC 12V cable to the connector of J101 on the device, the other side connect to DC 12V, you can use the DC 12v cable to supply power.

The other interfaces of the TM90M-4 device are shown in the following pictures.

FCC Regulations

•  This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
•  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference i n a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particuar installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
  •  Reorient or relocate the receiving antenna.
  •  Increase the separation between the equipment and receiver.
  •  Connect the equipment into an outlet on a circuit different from that to hich the receiver is connected.
  •  Consult the dealer or an experienced radio/ TV technician for help.
• Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To comply with FCC RF Exposure compliance require ments, this grant is applicable to only Mobile Configurations. The antennas used for the transmitter must be installed to provide a separation distance of at I east 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>