WOLF PW482418 48-Inch Pro Wall Hood Installation Guide
- June 4, 2024
- Wolf
Table of Contents
WOLF PW482418 48-Inch Pro Wall Hood
Assembly, blower
MOUNTING PLATE (SINGLE BLOWER ONLY)
Secure the mounting plate (shipped with the blower) to the blower with four
nuts.
24″ AND 27″ PRO WALL HOODS
- For single blowers only, remove the center section from the hood discharge.
- Install each blower using four nuts per blower.
PRO ISLAND, PRO CHIMNEY, PRO LINER, AND OUTDOOR HOODS
- Remove the two nuts from the blower mounting bracket, then remove the bracket from the hood.
- For single blowers only, remove the center section from the bracket
- Install each blower on the bracket using four nuts per blower.
- Align the tabs on the back of the bracket with the notches at the back of the discharge, then rotate thefront of the assembly upward and secure the assembly with the two existing nuts. Pro Hoods Internal Blower Installation www.subzero-wolf.com 800.222.7820 10/2021
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>