Schneider Electric M250 PowerTag Energy Instructions
- June 10, 2024
- Schneider Electric
Table of Contents
Electric M250 PowerTag Energy
Instruction Manual
Electric M250 PowerTag Energy
PowerTag M250 or M630 Mounting Instructions on the Plug-in Base ComPacT NSX100-250 or NSX400-630
This instruction sheet must be kept for future use.
Visit our website at www.se.com to download the
instruction sheets listed above and other documents.
PLEASE NOTE
- PowerTag devices must only be installed and maintained by qualified professionals.
- PowerTag devices should not be installed if, while unpacking, any damage is observed.
- PowerTag devices must not be repaired.
- The PowerTag devices must be installed inside electrical panels or switchboards, behind a door or plate, so that they are inaccessible for unauthorised persons. The electric panels must meet the requirements of the applicable standards (IEC 61439-1) and installed in compliance with current installation and safety rules (IEC 61140).
- All relevant local, regional, and national regulations must be respected while installing and using PowerTag devices.
- Schneider Electric declines any responsibility in the event that PowerTag equipment is associated with equipment that is not listed in the document CA908058E.
- Schneider electric is not liable in case the instructions mentioned in this document and other referred documents are not respected.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
- Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices.
- Turn off all power supply sources before installing and during maintenance of this equipment.
- Do not use a PowerTag product for voltage testing purposes. A Voltage Tester must be used instead.
- Replace all devices, doors, and covers before turning on power to this equipment.
Failure to follow these instructions will result in death or serious injury.
NOTICE
HAZARD OF POWERTAG M250/M630 DETERIORATION
Do not mount PowerTag M250/M630 if the rated network voltage is greater than
480 Va 50/60 Hz.
Failure to follow these instructions can result in equipment damage.
Dimensions
Installation
2.1 PowerTag M250 on ComPacT NSX100-250 Plug-in Base
To connect the 3 phases and the neutral on the main device, consult the relevant instruction sheet.
https://download.schneider- electric.com/files?p_Doc_Ref=QGH46815https://download.schneider- electric.com/files?p_Doc_Ref=NNZ4765407
2.2 PowerTag M630 on ComPacT NSX400-630 Plug-in Base
Fiber insulating plate not provided.
Schneider Electric Industries SAS
35, rue Joseph Monier
CS 30323
F – 92506 Rueil Malmaison Cedex
www.se.com
© 2021 Schneider Electric – All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>