WAFERLOCK L701 Smart Lock Installation Guide

June 10, 2024
WAFERLOCK

L701
WAFERLOCK CORPORATION
Installation GuideWAFERLOCK L701 Smart Lock -

L701 Smart Lock

WAFERLOCK L701 Smart Lock - fig 1

BOX CONTENTS

No. Parts Name Q’ty Remark
1 Outer handle set 1
2 Inner handle set 1
3 Handle 2
4 Battery holder 1
5 CR2 lithium battery 1 CR2 3V
6 Cover plate 1 For the inner handle set
7 Fixing pole 2
8 Spindle 1
9 Hexagon driver (#1.5) 1
10 Hexagon driver (#3.0) 1
11 Screw 2

1 Place the Door Drilling Template on the door.
Use a pin driver to mark the point where you need to drill.| 2 Drill the holes on the door according to the Door Drilling
Template.
If there is an existing mortise lock, remove it before drilling.
---|---
|
3 Install the spindle on the outer handle set and use hexagon driver (#1.5) to tighten the spindle.
The screw hole of the spindle must be at the bottom and the mark of the coupling must be on the top.| 4 Screw two fixing poles on the outer handle set.
|
5 Install outer handle set on the door.| 6 Turn the screw at the bottom of inner handle set clockwise
(go inside) until the cover plate can be pulled out.
|
7 Install inner handle set on the door, and screw the outer handle set and inner handle set tightly.| 8 Put the cover plate on the inner handle set.
|
9 Turn the screw at the bottom of the inner handle set anti-clockwise (go outside) until you feel resistance.| 10 Install the inner handle and use hexagon driver (#3.0) to tighten the screw on both inner and outer handle.
|
11 Use hexagon driver (#1.5) to turn the screw at the bottom of outer
handle set anti-clockwise then pull out the battery holder.| 12 Install CR2 lithium battery and install the battery holder back to the outer handle set.
|

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals