HALCYON R334 Tilt Rotate Kit Instruction Manual
- June 10, 2024
- HALCYON
Table of Contents
HALCYON R334 Tilt Rotate Kit
Installation Directions
- Switch off the mains power supply
- Connect Dimmable Driver to the mains voltage cable (L, N) Do not connect the downlight to the driver if the driver is live. Inrush current from live driver will cause instant downlight failure. Do not switch the secondary side.
- Carefully install downlight into Precut 82mmx2 hole.
- Turn on the mains power and switch on the lighting circuit.
Approved Clearances
Note : 0mm is required but 25mm is always recommended for optimum product lifespan through effective heat dissipation.
Example 1:
0mm Approved Height Clearance. Building element abutting rear, insulation
abutting sides of the fitting.
Example 2:
0mm Approved Side Clearance. Building element abutting side of the fitting,
insulation abutting, and covering fitting.
The driver is designed to be covered and abutted with IC / IC-F-approved
insulation
Cutting holes prior to receiving goods is entirely at the risk of the installer.
10 Basalt Place, East Tamaki, Auckland, PO Box 58-501, Botany, Manukau 2163,
Auckland, New Zealand
Ph (0064 9) 273-9177
Fax (0064 9) 273 9155
Email : sales@halcyon.co.nz
Web : www.halcyonlights.co.nz
CLASSIFICATION SHEET/ IC
Classification
| |
IC – building insulation that can safely be continuously exposed to 90°C allowed to abut and cover the luminaire.
---|---|---
In the vicinity of the recessed luminaire, use an insulation product that:
- Maintains its dimensions and structural integrity when exposed to a temperature of 90°C; and
- Withstands a 30-second needle flame test carried out in accordance with AS/NZS 60695.11.5 with the flame applied to all surfaces of the sample.
The rear of fitting may abut structural members and building elements. Do not
install through or directly into the joist, beam, rafter or ceiling
batten.
Recessed luminaires and their associated equipment may pose a risk of fire or damage to property if not installed and maintained correctly. Halcyon recommends a clearance of 25mm to building elements for optimum lifespan.
Halcyon IC-rated luminaires are completely safe to install in sarked timber ceiling linings
Halcyon accepts no responsibility if the timber used is not treated correctly
and dries out, cracks or warps over time due to the constant low heat from the
aforementioned “IC Rated” LED recessed lighting.
This data sheet contains the information necessary to ensure compliance with
the New Zealand Electrical Code of Practice for Installation and Maintenance
of Recessed Luminaires and Associated Equipment AS/NZS 60598.2.2:2001
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>