HALCYON LED444 DND LED Select Wide Body Batten Instruction Manual
- June 10, 2024
- HALCYON
Table of Contents
LED444 DND LED Select Wide Body Batten
Instruction Manual
LED444 DND LED Select Wide Body Batten
INSTALLATION INSTRUCTIONS
LEDE Select Wide Body Batten
LED444 DND (4 Ft)
40 / 60W, Non Dimmable, IP50, 4000K / 6000K
Factory Preset: 40W / 4000K
LED445 DND (5 Ft) 60 / 80W, Non Dimmable, IP50, 4000K / 6000K
Factory Preset: 60W / 4000K
Rated Voltage : 220-240V–, 50/60Hz
- Switch off mains power.
- Carefully remove end caps and diffuser.
- Fasten Batten chassis to mounting surface.
- Connect cable to terminal block as indicated. Adjust colour temperature and/or output wattage if required.
- Re-install diffuser and end caps.
- Switch on mains power to luminaire, test luminaire functions correctly and is electrically safe.
Warning: Do not install covered or positioned close to combustible
materials.
Colour temperature and wattage may be adjusted while fitting is live however
for safety purposes it is not recommended.
Installation note: Do not install on the same circuits as Metal halide,
Fluorescent and other “Low power factor” devices.
When installed on the same circuit it can cause flickering and/or premature
failure of the “high power factor” electronic drivers. The harmonic distortion
from low power factor devices alters the Waveform of the AC supply which can
cause componentry in high power factor electronic drivers to resonate, run
over temperature and fail after prolonged exposure.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>