BOSCH FNX425URFRD Acoustic Visual Alarm Instruction Manual
- June 10, 2024
- Bosch
Table of Contents
BOSCH FNX425URFRD Acoustic Visual Alarm
AVENAR all-in-one 4000
The AVENAR all-in-one 4000 is a fire alarm system produced by Bosch Sicherheitssysteme GmbH. It comes in four different models: FNX425URFRD, FNX425URFWH, FNX425UWFRD, and FNX425UWFWH.
Installation
The installation of the AVENAR all-in-one 4000 should only be carried out by authorized specialist personnel. It is recommended to use accessories and installation materials recommended by Bosch. The product should be assembled out of direct sunlight to ensure proper functioning and long service life. The operating temperature should be considered, and heat detectors of the AVENAR detector 4000 series should not be used for temperatures above EN54-5 category B. Refer to the detector documentation for information on detector installation and operation.
Battery Specification
The AVENAR all-in-one 4000 uses a single lithium battery pack with a battery life of approximately 10 years.
Sound Pressure Levels
The AVENAR all-in-one 4000 produces sound pressure levels of up to 97dB(A) with a frequency range of 440Hz to 2900Hz. The device complies with EN 54-3 and has two certified sound tones, no.1 decreasing (DIN tone) and no.24 slowly increasing.
Disposal of Batteries
The used batteries of the AVENAR all-in-one 4000 should not be disposed of in household waste. It is recommended to take them to local collection points. Further information can be found at www.boschsecurity.com/xc/en/weee/.
Product Usage
The AVENAR all-in-one 4000 is a fire alarm system that provides sound pressure level alerts in the event of a fire. It is designed to be installed by authorized specialist personnel using recommended accessories and installation materials from Bosch.
When installing the AVENAR all-in-one 4000, make sure to assemble it out of direct sunlight to ensure proper functioning and long service life. Also, consider the operating temperature and do not use heat detectors of the AVENAR detector 4000 series for temperatures above EN54-5 category B.
In the event of a fire, the AVENAR all-in-one 4000 will produce sound pressure levels of up to 97dB(A) with a frequency range of 440Hz to 2900Hz. The device complies with EN 54-3 and has two certified sound tones, no.1 decreasing (DIN tone) and no.24 slowly increasing.
Remember that used batteries should not be disposed of in household waste. Instead, take them to local collection points to ensure proper disposal.
| Max. 97dB(A)
---|---
| 440Hz … 2900Hz
| Red | White
| 1Hz | 0,5Hz
| 15V … 33V
| Max. 865 µA
| -10°C … +55°C
| IP 41
| 473g
| 145mm X 78mm
| 145mm X 111mm
| Plastic, ABS Red ~ RAL 3001
White ~ RAL 9010
| 0,14mm² … 1,5mm²
Installation notes
Caution!
The installation must only be carried out by authorized specialist personnel.
- Only use accessories and installation materials recommended by Bosch.
- Assembling out of direct sunlight, as this is the only way to ensure correct functioning and a long service life.
- Consider the operating temperature: Do not use a heat detector of the AVENAR detector 4000 series according to EN54-5 category B or higher.
- For information on detector installation and operation refer to the detector documentation.
Notice!
Batteries must not be disposed of in household waste. Please take used
batteries to the local collection points. See
www.boschsecurity.com/xc/en/weee/
for further information.
Notice!
For all sound pressure levels (low, medium, high) the certified tones, no. 1
decreasing (DIN tone) and no. 24 slowly increasing, comply with EN 54-3. The
document with certified sound measurements (F.01U.373.519) can be obtained
from the manufacturer.
Notice!
Max. series impedance (closed condition) ZC max = 805 mΩ ZC max AVENAR
detector 4000 = 440 mΩ
Line voltage to allow the device to be put into closed condition by the panel
(Vsc min to Vsc max), command sent by control panel: 16,7 V to 33 V (on a load
of 1,5A)
Line voltage to allow the device to be put into opened condition by the panel
(switch of command by the panel): 15 V to 33 V Electrical data for the built-
in short circuit isolator according to EN 54-17:2005, you find in
F.01U.003.287 for FLM-I 420-S.
Battery specifications
| Battery | 1 x Lithium battery pack |
|---|---|
| Battery life cycle* (years) | 10 |
- The typical battery life cycle depends on application behavior, operating temperature and environmental conditions. Incorrect handling leads to deviations. For more information about the typical battery life cycle, contact the manufacturer. Only use the device with Bosch battery pack (FNX-425U-BAT). Battery state shown on fire panel.
Bosch Sicherheitssysteme GmbH
Robert-Bosch-Ring 5
85630 Grasbrunn
Germany
www.boschsecurity.com
© Bosch Sicherheitssysteme GmbH, 2022
202209061422
Building solutions for a better life.