Pinghu TX6 Android TV Box User Manual
- June 10, 2024
- Pinghu
Table of Contents
TX6 Android TV Box
User Manual
TX6 Android TV Box
Operation manual:
For the first time to use Need to frequency bind
Take out the remote control,install the battery
long press on the button”M”for 2-4 seconds,Indicator light will flsh
Turn on the power of the car,Indicator light flashes to long lighting,then frequency bind succeed
If the frequency bind failed(Indicator linght flashes),remove the battey and repeat steps 1-3
remote control without operation after 10 seconds,Indicator light will off into power saving mode
Button Description: ▲ forward ▼ backward ◄ turn left ► turn right S:Speed
P:emergency brake,press it and the running functiong will fail,press again,it
releasefrequency:2405-2479MHz
FCC Warning
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>