SWAN SR12030CELN 80L Celtic Fronted Under Counter Fridge Instruction Manual
- June 3, 2024
- Swan
Table of Contents
80 LITRE
UNDER COUNTER COOLER
INSTRUCTION MANUAL
SRIZO30CELN
HELPLINE : 0333 220 6050
IMPORTANT SAFEGUARDS
Please retain these instruction for future use.
- Leave to stand upright for at least 4 hours before switching on to allow compressor oil to settle.
- Do not connect your appliance to the electricity supply until all packing and transit protectors have been removed.
- This product must only be used for its intended purpose i.e. the storing of edible foodstuff.
- See installation section for information on suitable location.
- On delivery, check to make sure that the product is not damaged and that all the parts and accessories are in perfect condition.
- Ensure that the plug remains readily accessible. Do not use multiple adaptor or extension cables.
- Failure to observe these instructions may invalidate your right to free service during the guarantee period.
GAS WARNING! CAUTION RISK OF FIRE!
The refrigerant gas (R600a) used in this drinks cooler is combustible.
When moving and installing the appliance, care should be taken to ensure that
no parts of the refrigerating circuit are damaged. If a leak is detected,
avoid any naked flames or potential sources of ignition and ventilate the
room in which the appliance is standing for several minutes. Servicing and
repair of R600a refrigerant must be done by qualified service technicians.
WARNING!
Do not use electrical appliances inside the food storage compartments of
the appliance, unless they are of the type recommended by the manufacturer.
-
Wesuggest you keep these instructions ina safe place for easy reference.
-
This appliance can be used by children aged from 8 years and above if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved.
Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and its cord out of reach of children aged less than 8 years. -
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
CAUTION!
In order to avoid a hazard due to inadvertent resetting of the thermal
cutout, this appliance must not be supplied through an external switching
device, such as a timer, or connected to a circuit that is regularly switched
on and off by the utility company.
This appliance should only be connected to an earthed, switched mains socket.
Do not use an extension cord with this appliance.
TECHNICAL DATA
Description: | 80 Litre Under Counter Cooler |
---|---|
Model: | SR12030CELN |
Volume: | 80L |
Energy: | E (pre 2021 A+) |
Refrigerant: | R600a (20g) |
Dimensions: | 435 x 474 x 840mm |
Power consumption: | consumption: 0.65A |
Voltage: | 220-240V ~ 50/60Hz C |
Climate type: | N |
Net weight: | 24kg |
GETTO KNOW YOUR COOLER
INSTALLATION NOTES
It is important that upon receipt, moving, or tilting to change the door hinge position, you stand your appliance upright for at least 4 hours before switching on. This will allow the gas and oil system to settle.
-
The appliance should not be tilted more than 45 degrees when you move it. Do not use force on any part such as the condenser, the door or handle. They could distort and affect the operation of the cooler.
Ensure ALL packaging is removed before installation. -
Make sure there is enough ventilation space around cooler. The cooler must not be built in to a cupboard or cabinet.
-
Ensure the supply voltage of socket is same as rating label.
-
The plug must be properly inserted to the wall socket.
-
The mains supply socket must be earthed – preferably with a switch. If it is not earthed, do NOT install this appliance there. Do not use an extension cord.
-
The product is equipped with adjustable feet. Once the product is in place, adjust these to ensure the cooler is level and doesn’t rock.
DO NOT SITE THE PRODUCT WHERE THE AMBIENT TEMPERATURE IS LIKELY TO DROP BELOW 5 DEGREES CENTIGRADE – EG: GARAGE OR SHED
FIRST TIME USE
-
It is important that upon receipt you stand your appliance upright for at least 4 hours before switching on to allow the system to settle. Remove all packaging & any transit tapes.
-
Clean the inside of the cabinet with a soft, dry cloth prior to switching on.
-
When using the product for the first time, set the thermostat inside to MAX without any bottles inside. When the appliance starts, you will hear the quiet hum of the compressor. You may also hear the circulation of liquids and gases in the refrigeration system. This is normal on first start up, Generally it will take up to 1 hour for the appliance to reach temperature.
Once temperature has been reached then put the drinks inside. -
The temperature of the cooler can be adjusted by rotating the disc of the thermostat. The higher the value on the setting of the thermostat, the maximum value of refrigeration (coldest being 5}. Typically a medium setting of 3 is best for most circumstances. Temperature range in the cooler is typically S – 12°C depending on thermostat setting.
-
Donot put too much foodstuff in the cooler. Avoid opening the door too frequently as this will waste energy.
REVERSING THE DOOR
This cooler has the capability of either opening the door from the left or
right side. The unit is delivered to you with the door opening from the left
side. Should you desire to reverse the opening direction, please follow these
instructions.
NOTE: All parts removed must be saved should you wish to restore the door
to original orientation.
- Remove the two screws (1) that hold the upper hinge (5) (right side} to the frame. Take away the upper hinge (5).
- Lift the door and place it on a padded surface to prevent scratching it (8).
- Remove the two screws (6 ) that hold the lower hinge (2) and make sure to remove the lower hinge (2).
- Remove the left front leg (4) and transfer it to the right side.
- Before placing this lower hinge (2), remove the bolt-pin (5) and reverse the direction of the lower hinge (2). Then install the lower hinge (2) onto the left side of the lower frame with two screws (6).
- Insert the bolt-pin (5) to the lower hinge (2).
- Locate the hole on the underside of the door onto the bolt-pin (5), square the door to the cabinet.
- While holding the door in the closed position secure the upper hinge (5) in the top frame of left side with two screws (1). Please note: do not tighten the two screws (1) until the top of the door is levelled with the top surface of the cabinet.
- Check the door opens freely and the seal makes full contact when door is closed.
CLEANING & MAINTENANCE
DAILY CLEANING
The outside of your cooler can be cleaned using a soft cloth moistened with
a mild detergent solution. Wipe dry with kitchen towel. Do not use chemical or
abrasive cleaners on any part of your cooler as these could permanently
damage or discolour the surfaces.
DOOR SEALS
Ensure that the door seals are kept free from debris at all times. If they
don’t seal properly this can waste energy.
CLEANING INSIDE
From time to time it may be necessary to clean the inside of the cooler
(e.g. after a spill).
- Switch off the cooler and remove plug from wall socket.
- Remove drinks and shelves.
- Clean the inside with a soft cloth moistened with a mild cetergent solution. Dry thoroughly with kitchen towel before replacing the shelves, drinks and switching the unit back on.
- Donotuse abrasive or chemical cleaners on any part of the cooler at any time.
CONDENSATION
Depending on the environment, you may notice a little condensation on the
outside of the glass door. This is normal and can be wiped away with a dry
cloth or piece of kitchen towel.
TROUBLESHOOTING
-
If the cooler does not run:
Check the supply voltage is available at the socket and check that the power plug is correctly connected. Check that the power switch near the thermostat/ light unit is switched ON. -
If the cooler does not become cold enough:
a. is the thermostat is set properly?
b. is there enough space around the cooler?
c. is the door opened too frequently or not closed properly? (check seals).
d. is there direct sun shine on the appliance or are there heat sources nearby?
e. is there too much foodstuff inside the compartment? (Do not put hot liquids in the cooler).
f. is there dust and debris built up on cooling matrix or compressor? -
If the cooler operates noisily:
a. Check that the appliance is installed on a stable, level floor. Adjust the feet if necessary. Is the cooler too near the wall?
b. The food stored in the cooler is not touching – particularly applies to glass containers. The cooler creates very slight vibrations, which can be amplified greatly with touching glass containers!
Note:
During high relative humidity environment, condensation may occur on the
surface of the cooler. This is not a malfunction. Simply clean the surface of
condensation.
If the cooler is not working properly after all these checks, contact the
service centre without further delay.
SERVICE & SPARES
If you experience any problems at all with your product or require spare parts, expert help is just a phone call away! 0333 220 6050
Spares List
Spare | Model No | Example |
---|---|---|
Door seal | SR12030N03 | |
Plastic Coated Shelf (Large) | SR12030N04 | |
Plastic Coated Shelf (Small) | SR12030N027 | |
Bulb 120V/10W 220V/10W | SR12030N026 |
For more information regarding bulb replacement, please see pages 11 & 12.
BULB REPLACEMENT GUIDE
Before starting , prepare the new bulb and unplug the unit from the power
socket. Open the door.
Step 1 : Remove the lampshade Fig.1 shows
the lampshade in its original position. Gently press down on the clip as shown
( fig . 2 ) . Next, pull o u t the lampshade b y pulling to the left whilst
pressing down (fig.3).
Step 2: Unscrew the bulb
Unscrew the bulb by hand by rotating the bulb counter-clockwise (fig.4), the lampshade and the old bulb should now both be f ully removed (fig.5).
Step 3: Install the new bulb
Screw in the new bulb by rotating clockwise (fig. 6). Ensuring that the new
bulb is safely tightened.
Step 4 : Re – install the lampshade
Re-insert the lampshade by sliding it back into position, from left to right ( fig . 7 ) . A clicking sound will indicate that the lampshade has been successfully re-installed (fig.8).
DISPOSAL OF UNIT
Disposal instructions for Swan items in accordance with the WEEE directive. Appliances bearing the symbol shown here may not be disposed of in domestic rubbish. You are required to dispose of old electrical and electronic appliances like this separately. Please visit www.recyclemore.co.uk, or www.recyclenow.co.uk for access to information about the recycling of electrical items. The WEEE directive, introduced in August 2006, states that all electrical items must be recycled, rather than taken to landfill. Please arrange to take this appliance to your local Civic Amenity site for recycling, once it has reached the end of its life.
WARRANTY
This product is guaranteed for one year from the date of original purchase.
If any defect arises due to faulty materials of workmanship the faulty product
will be repaired, refunded or replaced at our discretion.
The following conditions apply:
The product must have been purchased from new. Proof of purchase will be
required. The product must be installed and used in accordance with the
instructions contained in this instruction guide. It must be used only for
household and similar purposes such as:
- Staff kitchen areas in shops, offices and other working environments;
- Farm houses and by clients in hotels, motels and other residential type environments;
- Bed and breakfast type environments;
- Catering and similar non-retail applications.
The appliance has not been altered, serviced, dismantled or otherwise
interfered with by any person not authorised by Swan.
Any repair work must be undertaken by us or our appointed agent.
Any parts removed during repair work or any appliance that is replaced becomes
our property. It does not cover wear and tear, damage, misuse or consumable
parts. Swan Products Ltd has no liability for incidental or consequential
loss or damage. Food value is NOT covered by the warranty. This guarantee is
valid in the UK and Eire Only.
BSPLUG
The wires i n the mains lead are coloured in accordance with the following code:
BLUE | NEUTRAL |
---|---|
BROWN | LIVE |
GREEN/YELLOW | EARTH |
As the colours of the wire in the mains lead of this appliance may not
correspond with the colour markings identifying the terminals on your plug,
proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is
marked with the letter N or coloured black. The wire which is coloured BROWN
must be connected to the terminal which is marked with the letter L or
coloured red. The wire which is coloured GREEN/YELLOW must be connected to the
terminal which is marked with the letter E (or earth symbol} and is coloured
GREEN or GREEN/YELLOW.
WARNING: THIS APPLIANCE MUST BE EARTHED
PART OF THE
CELTICFC RANGE![SWAN SR12030CELN 80L Celtic Fronted Under Counter Fridge
- fig 11](https://manuals.plus/wp-content/uploads/2022/11/SWAN-SR12030CELN- 80L-Celtic-Fronted-Under-Counter-Fridge-fig-11.png)
YOU’LL NEVER WALK ALONE FOLLOW US
ONLINE – CELTICFC
Copyright © Swan Products L t d ,
PO Box 3117, Stoke-on-Trent ST4 9GD
Documents / Resources
| SWAN
SR12030CELN 80L Celtic Fronted Under Counter
Fridge
[pdf] Instruction Manual
SR12030CELN 80L Celtic Fronted Under Counter Fridge, SR12030CELN, 80L Celtic
Fronted Under Counter Fridge, Fronted Under Counter Fridge, Under Counter
Fridge, Counter Fridge, Fridge
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>