Pinghu Zhimeng Technology IM01 Ride-on Central Console Instruction Manual
- June 5, 2024
- Pinghu Zhimeng Technology
Table of Contents
Pinghu Zhimeng Technology IM01 Ride-on Central Console
Key description
- MODE : Switch music play mode and FM Radio mode.
- PREV : Switch to play the previous song.
- PLAY/PAUSE : Play/pause the music. Press and hold the Play/pause button to auto-scan radio stations. The Speaker will pause on stations with a clear signal, and the full scan will Complete after a couple of minutes. Any stations with a clear signal will Automatically save.
- NEXT: Switch to play the next song
- LAMP: Turn on/off the lamp.
- SPEED: Adjust the speed of the ride-on car’s movement as low, moderate or high
- FORWARD: Direct the ride-on car to move forward
- Backward: Direct the ride-on car to move backward
- B: Bluetooth mode
- Parameter description
| Parameter | Min | TYP | MAX | Uint |
|---|---|---|---|---|
| 12V version | 7 | 12 | 14 | V |
working
temperature
| -10| | 40| ℃
Lamp
current
| 0| | 1| A
Speaker
Power
| 0| | 8| W
USB| 0| | 64| Gb
TF| 0| | 32| Gb
FCC WARNING
- This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- This device must accept any interference received, including interference that may cause undesired operation.
- Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures :
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- To maintain compliance with FCC’s RF exposure guidelines, This equipment should be installed and operated with a minimum distance of 20cm from the radiator of your body: Use only the supplied antenna.