Pinghu Little Sun Childs Vehicles S503 Electric Kids Ride-On Car Instruction Manual
- June 5, 2024
- Pinghu Little Sun Childs Vehicles
Table of Contents
- Pinghu Little Sun Childs Vehicles S503 Electric Kids Ride-On Car
- SAFETY
- USER WARNINGS
- SPECIFICATIONS
- PRODUCT ASSEMBLY (SINGLE DRIVE)
- Follow the assembly steps in the order listed below
- CA RING FOR YOUR RIDE-ON
- TROUBLESHOOTING
- FCC Statement
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Pinghu Little Sun Childs Vehicles S503 Electric Kids Ride-On Car
SAFETY
Please retain these instructions for future reference.
NOTE:
For best performance,only use this vehicle on flat and hard surfaces. AGE
RANGE:3 to 8 years old
WEIGHT CAPACITY:
30KG is the maximum weight for 1rider(combined) The following safety hazards
may result in serious injury or death:
- This product contains small parts.Keep children away during assembly.Make sure to remove all packaging material and parts from underneath the vehicle body.
- Never open the battery.Batteries contain lead and lead compounds(acids).
- Limbs,hair,and clothing can get caught in moving parts.Always wear shoes,keep limbs away from moving parts,and do not wear loose clothing while operating this vhicle.
- This vehicle does not have brakes or braking capability.Do not leave a child unattended during operation.DO not use this in a location that may require braking capability.as this could result in loss of control,which may cause serious injury or death.
- Use of this vehicle near streets,motor vehicles,steps,bodies of water,sloped surfaces,hills,wet areas,flammable vapors,in alleys,at night,or in the dark could result in an unexpected accident.
- Usu of this vehicle in unsafe conditions such as snow,rain,loose dirt,mud.sand,or gravel may result in an unexpected accident such as tipping over,and could damage the electrical system or battery.
- Do not operate this vehicle in an unsafe manner.Examples include but are not limited to:
- pulling the vehicle with another vehicle or similar device
- Allowing more than two children to ride
- Pushing the user
- Traveling at an unsafe speed
The following safety hazards may result in serious injury or death:
- Use of a battery or charger other than the supplied rechargeable battery and charger may cause a fire or explosion.Only use the supplied battery and charger.
- Use of the rechargeable battery and charger for any other product may result in overheating,fire,or explosion.Never use the supplied rechargeable battery and charger with another product.
- Explosive gases are created during charging.Charge the battery in a well-ventilated area.Do not charge the battery near heat or flammable materials.
- Contact between the positive and negative terminals may result in fire or explosion.Avoid direct contact between the terminals.Picking up the battery by the wires or charger can cause damage to the battery and may result in a fire .Always pick up the battery by its case or handles.
- Liquids on the battery may cause fire or electric shock.Always keep all liquids away from the battery and keep the battery dry.Contact or exposure to battery leakage(lead acid)may cause serious injury.If contact or exposure occurs immediately call your physician.If the chemical is on the skin or in the eyes,flush with cool water for 15 minutes.If the chemical was swallowed,immediately give the person water or milk.Do not give water or milk if the
- atient is vomiting or has a decreased level of alertness.Do not induce vomiting.
- Battery posts,terminals,and related accessories contain lead and lead compounds(acid)
- Tampering or modifying the electric circuit system may cause a shock,fire or explosion and permanently damage the system.Exposed wiring and circuitry in the charger may cause electric shock.Always keep the charger housing closed.
USER WARNINGS
The foll owing safety hazards may result in serious injury or death:
- Never leave a child unattended.
- Always sit in the seat when using this vehicle.
- Keep your hands,hair,and clothes away from moving part.
- Always wear shoes when operating this vehicle.
- Maximum of two children are allowed in the vehicle at a time.
- Children under 3 years of age cannot use the vehicle.
- Only drive on level ground.
- Do not go near swimming pools or other bodies of water,drop-offs,or up and down steep inclines.
- Do not drive the vehicle into loose dirt,mud,sand,fine gravel,or on wet surfaces.
- Do not drive the vehicle on streets or near cars.
SPECIFICATIONS
Item | Specification |
---|---|
Batteries | 6V / 12V |
Motor | 6V / 12V |
Age | 3-8years |
Max Weight | 30KG |
Dimension | 97×56.5×46cm |
Speed | 1.5-2.8km/hr(6V)/ 2-3km/hr(12V) |
Play Time | 1-2 hours / recharger time 8-12hours |
Charger | Output DC 12V (Dual drive) |
Charger | Output DC 6V (Single drive) |
PRODUCT ASSEMBLY (SINGLE DRIVE)
Put the gasket, Cart wheels, gasket and cotter pin into the front axle in turn. Insert the cotter pin into the hole of iron piece and bend it to fix itand then attach the wheel cover to the wheel.
Place the Cart wheels, Washer, and cotter pin on the rear axle in turn. Insert the cotter pin into the hole of iron piece and bend it to fix itand then attach the wheel cover to the wheel. Put the gasket, Cart wheels, gasket and cotter pin into the front axle in turn. Insert the cotter pin into the hole of iron piece and bend it to fix itand then attach the wheel cover to the wheel.
Place the Cart wheels, Washer, and cotter pin on the rear axle in turn. Insert the cotter pin into the hole of iron piece and bend it to fix itand then attach the wheel cover to the wheel.
- Place the rear bumper reinforcement on the body as shown in the figure;
- And fixed with M4 *10 screw;
- Put the vehicle upside down
Find the main power cord under the seat and insert the plug of the power cord into the corresponding jack of the receiver
Follow the assembly steps in the order listed below
Attach the steering wheel.
- Remove the nut and bolt from the steering wheel.
- Connect the wires coming from the steering column to the wires on the steering wheel.
- Insert the steering wheel over the steering and secure with nut and bolt.
Fix the seat
- Stuck the seat buckle into the vehicle slot
- Press the seat switch to fix the sea
- Stuck the mirror into the windshield and fix it with M4*10 screws;
- Stuck the windshield into the corresponding slot on the body
- Pedal button: Step on the button , the car will move when release,the car slowly stop
- Shift Switch: Change the direction of the car , Forward-Backward
- Horn button: press to play the horn
- Control board:
- Power button:Long Press it 3 seconds,Turn the vehicle on and off
- Wireless Technology : After connected your mobile phone and the wireless device ,the car can play music from your mobile phone
- FM: Radio, long press it 2-3 seconds, the light of FM button will flash and Automatic search, when the search completes, the FM key stops flashing
- Music Button:play music
- Last song:Switch songs/and long press will decrease volume
- High speed button:change the speed of the car more quickly
- Slow speed button:change the speed of the car more slowly
- Light button : Turn on or off the light
- Next song:Switch songs/and long press will increasevolume
- U
- Socket:charge
- Power display:Clearly see the battery power,in order to charger in time
Remote control first. When the remote control is on, foot pedal is not
workable
Operation Manual:
Take out the remote control, Open the battery compartment on the back of the
remote control and add two AAA LRO3 alkaline batteries. Pay attention to the
polarity of the batteries. When the alignment light and speed indicator light
up, it indicates that the battery installed is correct. This product does not
provide dry batteries.
-
1. Long press on the frequency key(M) 2-4 seconds, Low speed LED light flashing. Turn on the power of the car, Low speed LED light keep flashing to long lighting, then frequency bind succeed. If the frequency bind failed (Low speed LED light flashing) , remove the battery and repeat steps
-
Press to brake。
-
Speed:press to change speed(low,middle and high speed) 2) Brake button: Press it to stop moving; press it again to move. Speed selection key and speed indication: used to select speed of the car. Press the key once to switch the speed once. 3 speeds are cyclically switched, and the switching sequence is: low-medium-high.
-
The speed indicator is arranged from top to bottom on the remotecontrol: high-speed lamp, medium-speed lamp, low-speed lamp; when switching to one speed, the corresponding indicator lamp will light up. Note: The speed grade changes only when moving forward
-
Forward/backward keys: used for forward and backward movement control. When one of the keys is pressed, the moving speed will slowly increase to reach the set speed level. Therefore, children will not have a sudden impact.
-
Left turn/right turn key: used for left and right direction control. Note:without operation after 10 seconds, indication light will off into power saving mode
-
Insert the charger jack into the charging hole of the car.
-
Plug the charger plug into the stable matching AC power supply as shown in the picture.
- Charge the battery 15 to 18 hours before initial use.
- On average.you will need to charge the battery between 8 and 12 hours.Do not charge the battery for more than 20 hours.Failure to charge the battery as directed could cause permanent damage to the battery and void the warranty
- Damage to the battery may occur if it is allowed to drain completely.Do not allow the battery to drain completely.
- Check the battery and charger (supply cord,connector) for wear and damage before charging.DO not charge the battery if damage has occurred.
- Only an adult who has read and understood the safety warnings should handle,charge and recharge the battery.
CA RING FOR YOUR RIDE-ON
- Park the vehicle indoors or cover it with a tarp to protect it from wet weather.
- Do not leave the vehicle in the sun for long periods of time or fading may occur. Store in shade or cover with tarp.
- Do not wash the vehicle with a hose.
- Do not wash the vehicle with soap.
- Charge battery at least once a month to prolong the life of the battery.
TROUBLESHOOTING
PROBLEM | REASON | SOLUTION |
---|
Vehicle does not move
| Low battery| Fully charge the battery
Electrical protection| Stop use for several minutes and restart
Switch not in the correct position| Completely press in switches
Battery connectors disconnected| Plug in battery connectors
Battery does not recharge
| Battery connectors disconnected| Plug in battery connectors
Charge not connected to socket or outlet| Completely plug in the charger
Battery does not last| Battery does not have a full charge| Fully charge the
battery
Battery is warm and makes a
slight noise while charging
|
Normal
|
Normal
Slow speed
| Low battery| Fully charge the battery
Overloaded vehicle| Reduce the weight on the vehicle
Uneven or sloped road| Drive on flat pavement
Vehicles shakes while driving
|
Loose connection to motor
| Ensure the motor is properly connected
to the battery
Difficulty shifting between
forward/reverse
| Attempting to shift while vehicle in
motion
|
Only shift when the vehicle is at a stop
Forward and reverse switch is
flipped
|
Gear boxes are installed incorrectly
| Make sure the L gear box is on the left
and R gear box is on the right
The battery on the vehicle is not replaceable.
- DO not mix old and new batteries.
- Non-rechargeable batteries should not be charged.
- Rechargeable batteries should be charged under adult supervision only.
- Exhausted batteries should be removed.
- The supply terminals should not be short-circuited.
- Do not put batteries next to or in a heat source(fire,electronic heating device,etc.)
- Do not hit batteries against hard objects.
- Do not submerge batteries in water.
- Batteries should be inserted with the correct polarity.
FCC Statement
Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: this device may not cause harmful
interference.this device must accept any interference received, including
interference that may cause undesired operation. Changes or modifications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>