Foxwell F1000B OBDII Scanner and Battery Tester User Guide

: June 10, 2024
: Foxwell

Table of Contents

Vehicle/Battery Connection
Tester Descriptions
Updating
Retrieve I/M
To Print Test Results
Contact Us
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Foxwell F1000B OBDII Scanner and Battery Tester User Guide

Vehicle/Battery Connection

OBDII/EOBD Test

Locate the data link connector (DLC) under the dash on the driver side of the vehicle.
Plug the tester to the vehicle DLC with OBDII adapter.
Switch the ignition key to the ON position.
Choose OBDII/EOBD APP to start test.

Battery Test

If you are testing the battery inside a vehicle, make sure all accessory loads are cut off, the key is not in the ON position and the doors are closed

Connect the current clamp cable to the OBD adapter of the scanner
Clean the battery posts or side terminals
Connect the red clamp to the positive (+) terminal and the black clamp to the negative (-) terminal.
When the tester is correctly connected, choose Battery App to start test.

Tester Descriptions

A OBDII Cable
B LCD Display
C Green LED Display – indicates the engine system is working normally and no DTCs are found
D Yellow LED Display – shows the tool finds a possible problem. Pending DTCs exist or/and some of the vehicle’s emission monitors have not run their diagnostic testing.
E Red LED Display – indicates there are some problems in one or more of the vehicle’s systems. In this case, the MIL lamp on the instrument panel is on
F UP Key
G DOWN Key
H LEFT SCROLL KEY
I RIGHT SCROLL KEY
J I/M Readiness (F3) Key – quick checks state emissions readiness and drive cycle verification.
K BACK Key
L OK Key
M Help (F4) Key – accesses to help information.
N ER (F2) Key – accesses to Erase code
O DTCs (F1) Key – to read the stored DTCs.
P USB port
Q Battery Clamp Cable – connects with the device to perform battery testing function.

Updating

Do not disconnect the Tester from computer or power off the computer during the process of updating.
No Registeration Required
PC : Windows 7, Windows 8 and Windows 10 supported

The Upgrade Process

Download the update tool NT Wonder and install it.
Enable NT Wonder and connect F1000B to the computer with USB cable
Click Update online or Update offline to start update according to the software version conditions.
An Update Finished message displays when the update is completed

Retrieve I/M

Malfunction Indicator Lamp

Diagnostic Trouble Codes

Misfire

Fuel System

Comprehensive Component Monito

Catalyst

Heated Catalyst

Ignition

Pending Diagnostic Trouble Codes

Evaporative System

Intake Air System

Oxygen Sensor

Oxygen sensor heater

Exhaust Gas Recirculation

To Print Test Results

The test results stored in the tester and can be printed through computer. Test data can only be imported to your computer through NT Wonder.

Connect the tester to the computer via USB cable provided.
Launch NT Wonder and choose Print Button from the menu.
Click Print key on NT Wonder to print the test data.
Select Print Data from home screen of the tester and choose the data you want print from the option.