RAYO MOVIL R3 Mobile Phone User Manual
- June 10, 2024
- RAYO MOVIL
Table of Contents
RAYO MOVIL R3 Mobile Phone User Manual
Declaration
Please read the user’s manual to keep your mobile phone in the best condition. The manual has been verified and reviewed to guarantee the accuracy. Instructions and descriptionsContained herein are accurate at the time of publication. However, mobile phones developed afterward, and the contents of their manual are subject to modification without further notification. Our company reserves the rights m relation to the manual.
Introduction
-
Password
Phone password
With the phone password, you can prevent others from using your mobile phone without your approval. The original phone password Is 1234. -
Insert the slm card and the battery
Ensure to turn off the equipment and discomect %nth the charger before taking out the battery. -
Startup and shutdown
Press the key of power supply to start up or shut down the mobile phone. If itsprompted to input PIN or UPIN, please input the required password (shown as • •••• • on the screen). -
Antenna
Your mobile phone may be provided with bulloin and exposed antenna. lust like using any other radio and transmitting devices, don’t touch the antenna If not necessary because It may affect the quality of telecommunication and result in equipment operating in an energy level higher than required, thus shortening the service life of the battery.
Input Methods
Need to be sure to change one of Input Methods.
Phone Book
You may save the information of contacts including names & telephone numbers in the phone book. The storable entries of sim card depend on the type of the card.
Message
- SMS
The cell phone supports sending of and receiving of SMS. You may check the quantities of sent and received messages from the menu of SMS counter.
Write a message: You may select multiple receivers to send the message to more nun 1 person. SMS setting: You may select to edit the SMS setting either of SIM card 1 or 2, where, you can edit the number of the service center (Which is obtained from the service provider).
Settings
General
Security setting
You may set functions in relations to cell phone security. (phone lock:12341
Restore the factory settings
Enter the correct password of the phone will have to change your phone
settings back to factory default state value, the user of the function be used
with caution. (Default password: 12341.
Phone
Network seeded
The option is related to your network provider. Please get in contact with the
network provider for that.
Flight Mode: No communication function Is available m-flight model.
Switch mode
You may select modesof dual-standby and single-pass, SIM 1 on/SIM Son and
flight mode.
WAP
You may surf online with WAP Brower, which means that you may surf online at any time and in any place. For details, please get in contact with the nearest network service provider.
Video recorder
In the options of the video camera, you may set the exposure compensation, avoidance of fkkering, white balance, special effect, profile etc.
Camera
In the options of camera, you may set the photometry mode etc. You may enter the album to check the formats that the cell phone supports.
Audio Player
The music player is used to play music files In supported formats in the current player’s list.
Video player/Image Viewer
Check the video or pictures files supported by the cell phone.
File manager
For the memory card, you may est-abash a data file folder etc.
Call history
The call list lists all types of calls, Including missed ones, dialed ones and answered ones, or you may enter the separate lists of missed calls, dialed calls and answered calls for check or Operation.
FM Radio
Turn on/FM broadcast, and you may manually tune the channel.
Recorder
Use this function you can record or listen to your own record.
Connection
Edit and set the CPAS access point Note: The*account data’ is to be provided by the network operator.
Alarm
Set the time of alarm clock. At the time of alarm clock, an alarm nng will be given as Per the setting.
Bluetooth
You may establish wireless connection with other compatible devices with the Eiluetooth technology.
PC connect
- Mass storage
Use the T-Flash insened in the mobile phone as U-D.Ms.
Lamp
Support Lamp function.
Calendar
Support Calendar function.
Calculator
Support Calculator (unction.
SOS
Support SOS function.
Original Accessories
Refer to the local dealer for supply of accessories. Hereafter are some precautions for usage of the accessones:
-
Please keep the accessoriesout of children’s reach.
-
Hold the plug and pull out instead of pulling the power cord when CIJI off the power supply.
-
Regularly check the mobile equipment in the automobile to see whether they are correctly installed and whether work normally. Only use batteries. chargers and accessories approved by the manufacturer. Usage of other types of batteries. chargers and accessories may result in violence of the certification or warranty terms or even lead to danger. Why Is required to use the original accessories? Battery and charger are key parts of a mobile part because they play important roles in guaranteeing the normal operation of the mobile phone as well as your safety. It is shown in our longterm customer investigation and aftersales service that lots of mobile phone failures results from usage of ineligible accessories, especially ineligible battery and charger. Hazards resulting from usage of ineligible battery and charger
-
Shorten the battery service life with times of battery charging/discharging much fewer than that of the original battery.
-
Shorten the service life of the mobile phone largely. Unstable voltage will affect the normal operation of the circuit, resulting permanent damage.
-
Affect the performance and reliability of the mobile phone, reducing the voice quality and being susceptible to halted system.
-
May result in bunting or explosion and thus endanger the personal safety of the customers.
About the battery
-
Charging and discharging
Chargeable battery is used for the equipment. The batten, may be charged and discharged for several hundreds of tines and finally will be disabled. In case the standby time and cal duration shorten obviously. please replace the battery. If the battery is replaced and used for the first time, or the battery has been kept for a long time before using, It may be necessary to connect with the charger, disconnect and then reconnect In order to charge the battery. Mien the charger is not used, please disconnect with the equipment and plug it out from the power socket.
If the battery runs out of electricity, you may have to wait for a few minutes till the symbol of charging is shown on the screen, and then you can make and answer any call. Don’t use the battery for any other purpose. Don’t use any damaged charger or battery. -
Usage and treatment of battery
AvoRI short circuit of battery; otherwise, the battery may be damaged, and generate heat to cause fire hazard;
Don’t put the battery under high temperature or in fire; otherwise, it may explode; Don’t attempt to take apart the battery: Stop usage in case of damage or obvious aging of battery and charger; Returnwaste and used batteries to the supplier or specified recovery site. Don’t throw it away in domestic garbage.
Maintenance and service
Your equipment is a product with exquisite design and process. Please use carefully. Following are some suggestions for you to effectively use the maintenance service.
- Keep the equipment dry. Rainwater, moisture, other liquids or moisture contents may contain mineral matters, which may erode the electronic wires, if the equipment is wetted, please take out of the batter/till the equipment Is totally dried and then put In the battery.
- Don’t use or store the equipment in dusty or filthy places: otherwise, the detachable parts and electronic elements may be damaged.
- Don’t put the equipment in overheated places.
- Don’t keep the equipment in under cooled places; otherwise, when the temperature rises to normal, moisture may be generated within the equipment, resulting in damage of the circuit board.
- Please open the equipment as per the descriptions In the manual. Don’t try any other means.
- Don’t throw, knock or shake the equipment. Arty rough treatment of the equipment may result in damage of the inner circuit board and its exquisite structure.
- Don’t clean the equipment with ardent chemical, detergent or strong wash.
- Don’t paint any dyestuff on the equipment. Painting may block foreign substances in detached parts and thus affect the normal operation.
- Clean the lens with clean, dry soft loth (such as the camera lens, range senser and light sense.).
- Only use matched or approved antenna for substation of the damaged one. Unapproved antenna, alteration or accessories may result in damage of the equipment and violence of relevant specifications on ra154. equipment.
- Pietae use the charger in indoor area.
- Back up data that should be kept (such as the address director( and calendar memorandum).
- Please turn off the equipment and take out the battery to restore the equipment setting irregularly to maintain the optimal Performance-
- The above suggestions also apply to your equipment, battery, charger and other accessories. In case any device doesn’t work, pease take it to the nearest authorized maintenance agency for repair.
FCC Caution
Labelling requirements. This device complies with part 1S of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular Installation. If this equipment does cause harmful Interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC rules. Operation is subject to the following hvo conditions (1)this device may not cause harmful Interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio
waves. The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough evaluation
of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons regardless of age or health. FCC
RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg
averaged over one gram of tissue. Device types: Portable Equipment (FCC ID:
2AEJAR3) has also been tested against this SAR limit. The highest SAR value
reported under this standard during product certification for use at the ear
is 0.19 W/Icg and when properly worn on the body is 0.18 W/kg. This device was
tested for typical body-worn operations with the back of the handset kept 10mm
from the body. To maintain compliance with FCC RF exposure requirements, use
accessories that maintain a 10mm separation distance between the user’s body
and the back of the handset. The use of belt clips, holsters and similar
accessories should not contain metallic components in Its assembly. The use of
accessories that does not satisfy these requirements may not comply with FCC
RF exposure requirements, and should be avoided.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 10mm must be
maintained between the user’s body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that do not
meet these requirements may not comply with RF exposure requirements and
should be avoided. Use only the supplied or an approved antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>