HUBBELL SGC-20-4K Ceiling Surface and Garage Light Instruction Manual

June 4, 2024
Hubbell

HUBBELL SGC-20-4K Ceiling Surface and Garage Light

HUBBELL SGC-20-4K Ceiling Surface and Garage
Light

INSTALLATION INSTRUCTIONS – SLING CANOPY

WARNING!

Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes. Failure to do so may increase the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH. Install and use so fixture failures do not cause a hazard and use only in environments for which the product is specifically marked.

WARNING!

This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.

CAUTION!

  • Follow ALL luminaire recommendations, product markings, instructions, restrictions and warnings regarding luminaire operation and burning position.
  • Luminaire label shows electrical and environmental requirements and restrictions.
  • All electrical work must be done by a qualified electrician.
  • Turn off electric power to all affected circuits and allow to cool before servicing.
  • A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat retention.
  • Dusting with a soft, clean, dry cloth is normally sufficient for the optical system. Any accumulation of dust or dirt should be removed regularly.
  • Carefully read these instructions before installing product. If you do not understand these instructions, before starting any work, contact your Hubbell Lighting distributor or techsupport@hubbell-ltg.com or 864-678-1000
  • Give instructions to facility owner/manager for future reference.

NOTE:

This luminaire is designed for outdoor lighting applications with ambient temperatures not exceeding 40°C

WARNINGS:
Dangerous voltage exists within the unit and all precautions usually observed in handling high voltage equipment should be observed when replacing light engine or otherwise servicing luminaires. Disregarding this warning could result in electrical shock and possible injury to the individual installing or servicing this equipment. Installation and servicing should be done by qualified personnel.

Tools Required

  • 2 Phillips Head Screwdriver

Pendant Mounting

  • Install ¾” threaded pipe into the opening of the housing and tighten provided set screw

Note: When using fixture as a pendant mount use waterproof pipe joint compound. (Not Provided)

1B. Surface/J-Box Mounting

  •  Remove mounting bracket from the fixture by loosening screw , then sliding the mounting bracket in direction indicated, then lifting away from the fixture. Detach wire form from clip .
  •  Install Mounting Bracket to the surface or J-Box using the hole pattern provided. (Hardware provided by others)
  •  On the bracket, tilt the wire form down. Slide the wire form under the clip on the fixture.
  •  Connect the supply wires in accordance with local and National Electrical Codes. Push excess wires in to the junction box.
  •  Guide the fixture onto the feet of the mounting bracket. Once the mounting feet are engaged, slide the fixture towards the hook on the mounting bracket.
  •  Secure the fixture by retightening the mounting screw. HUBBELL SGC-20-4K Ceiling Surface and Garage Light 2

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Hubbell User Manuals

Related Manuals