HUBBELL WGH2 Glass Wallpack Small Adjustable Outdoor Lighting Instruction Manual
- June 4, 2024
- Hubbell
Table of Contents
HUBBELL Outdoor Lighting
INSTALLATION INSTRUCTIONS – WGH Glass Wallpack Small Adjustable
SAVE THESE INSTRUCTIONS
WGH2 Glass Wallpack Small Adjustable Outdoor Lighting
WARNING! Fixtures must be grounded and installed in accordance with the
National Electrical Code and all local codes. Failure to do so may increase
the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE, AND DEATH. Install and use
so fixture failures do not cause a hazard and use only in environments for
which the product is specifically marked.
WARNING! This product contains chemicals known to the State of California
to cause cancer, birth defects, and/or other reproductive harm. Thoroughly
wash hands after installing, handling, cleaning, or otherwise touching this
product.
WARNING! Dangerous voltage exists within the unit and all precautions
usually observed in handling high voltage equipment should be observed when
replacing a light engine or otherwise servicing luminaires. Disregarding this
warning could result in electrical shock and possible injury to the individual
installing or servicing this equipment. Installation and servicing should be
done by qualified personnel.
CAUTION! Follow ALL luminaire recommendations, product markings,
instructions, restrictions and warnings regarding luminaire operation and
burning position. The luminaire label shows electrical and environmental
requirements and restrictions.
NOTE! This luminaire is designed for outdoor lighting applications with
ambient temperatures not exceeding 40°C (104°F). All electrical work must be
done by a qualified electrician. Turn off the electric power to all affected
circuits and allow to cool before installation or servicing.
A regularly scheduled maintenance program should be established to retain
optimum light output and reduce heat retention. Dusting with a soft, clean,
dry cloth is normally sufficient for the optical system. Any accumulation of
dust or dirt should be removed regularly.
Carefully read these instructions before installing the product. If you do not
understand these instructions, before starting any work, contact your Hubbell
Lighting distributor or techsupport@hubbell-ltg.com or 864-678-1000 Give
instructions to the facility owner/manager for future reference.
See figure 1 if wanting to mount it directly to the wall. This is showing the back of the housing. You will need to drill through the housing taking care not to drill into internal items. You will also need to use the dimensions provided to drill and install the wall anchors (provided by others) to your wall. 1/2″-14 cast plugs have also been provided. If you would rather install direct to a junction box, see the next page for those installation steps.
93139881 Rev-B
READ THOROUGHLY BEFORE INSTALLATION
If your light fixture was supplied with a photocell it may have a black
photocell cap installed on it, see figure 2 to determine if the cap is
installed. With the cap installed your light will always be on when power is
applied unless a switch is used to turn the light on or off. If you want the
photocell to turn off the light when it is daylight, remove the cap and
discard it.
Your light fixture can be mounted directly to a junction box. See figure 3 for
junction box mounting details. Drill through the housing in this area to match
your junction box screw locations. Make sure to install the gasket as shown in
figure 1.
| 
---|---
93139881 Rev-B
Hubbell Lighting 701 Millennium Boulevard
Greenville, SC 29607 Phone:
864-678-1000
Due to our continued efforts to improve our products, product specifications
are subject to change without notice.
© 2021 Hubbell Lighting, All Rights Reserved For more information visit our
website: www.hubbelloutdoor.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>