Silverlit MY487-R38 Aqua Typhoon Scale Instruction Manual

Silverlit MY487-R38 Aqua Typhoon Scale

Product Information

The EI-7627d is a remote-controlled vehicle that comes with a Li-ion battery pack and USB. It requires 2 x AA batteries for the transmitter.
The vehicle and the transmitter have an ON/OFF switch.
The maximum distance between the transmitter and the vehicle should not exceed 20 meters.

Product Usage Instructions

Installing batteries in the transmitter

1. Open the battery compartment of the transmitter.
2. Insert 2 x AA batteries with correct polarity.
3. Replace the battery compartment cover.

Installing the vehicle battery

1. Make sure the ON/OFF switch of both the vehicle and the
   transmitter is set to OFF.

2. Open the battery compartment of the vehicle.

3. Connect the Li-ion battery pack to the vehicle.

4. Replace the battery compartment cover.

Starting

1. Screw the antenna into the hole on the top of the transmitter if necessary.
2. Extend the antenna fully.
3. Make sure the ON/OFF switch of both the vehicle and the transmitter is set to ON.
4. To move the vehicle forwards or backwards, push the throttle lever forwards or backwards or press the trigger (depending on the model).
5. To turn the vehicle left or right, press the steering lever to the left or right. Or, depending on the model, turn the steering wheel or move the two levers in opposite directions to turn.
6. To stop the vehicle, release the throttle lever.

Troubleshooting Guide

If you encounter any issues, please check the following:

• Make sure the vehicle power is on.
• Make sure the batteries in the transmitter and vehicle have sufficient charge and are inserted with correct polarity.
• Make sure the distance between the transmitter and the vehicle will not exceed more than 20m.
• If two or more vehicles of the same frequency will interfere with each other, move to another place or try after a while.

Product Overview

A  Product Installing batteries in the transmitter

1. Open the battery compartment.
2. Insert batteries, respecting the + and – polarities.
3. Replace the cover.

B Product  Installing the vehicle battery:

1. Make sure the ON/OFF switch is set to OFF.
2. Open the battery compartment.
3. Connect the battery to the vehicle.
4. Replace the cover.

C Product Starting:

1. If necessary, screw the antenna into the hole on the top of the remote control.
2. Extend the antenna fully. Start the car.
3. To move the car forwards or backward, push the throttle lever forwards or backward or press the trigger (depending on the model).
4. To turn the vehicle left or right, press the steering lever to the left or right. Or, depending on the model, turn the steering wheel or move the 2 levers in opposite directions to turn.
5. To stop the vehicle, release the throttle lever.
6. For best performance, always point the antenna towards the car.

Product TROUBLESHOOTING GUIDE

• Make sure the vehicle’s power is on.
• Make sure the batteries in vehicle have sufficient charge.
• Check if the batteries in transmitter and vehicle are inserted with correct polarity.
• Check if the distance between transmitter and vehicle will not exceed more than 20m.
• Two or more vehicles of the same frequency will interfere with each other. In such a case, move to another place or try after a while.

WARNING:
CHOKING HAZARD – Small Parts. Not for Children Under 3 years.

Manufacturer : Silverlit Toys Mfy Ltd. Rm 1102, 98 Granville Road, Kowloon, Hong Kong

Imported/distributed by : SILVERLIT SAS 80, rue Barthelemy Danjou 92100 Boulogne-Billancourt France

The symbol showing a crossed-out rubbish bin indicates that or-dinary batteries, rechargeable batteries, button batteries, battery packs etc. should not be disposed of with household waste. Batte-ries are dangerous for health and the environment. Help to protect the environment against health risks. Ask your child to dispose of batteries cleanly by taking them to your local collection points. In this way, batteries can be recycled safely.

WARNING ! Not suitable for children under the age of 3. Contains small parts which can be detached and swallowed. Risk of suffocation. BE CAREFUL : Packaging must be retained since it contains important information. Right is reserved to effects changes in colors and technical details. MADE IN CHINA. Hereby, Silverlit Toys Ma-nufactory Ltd declares that the radio equipment type SK17001 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is avai-lable at the following internet address: www.silverlit.com/a/certificate

Waste electrical and electronic equipment (WEEE):
When this device reaches the end of its life, please remove all batte-ries and dispose of them separately. Take electrical devices to a col-lection centre for electronic equipment and household appliances. Other components can be disposed of with household waste.

The use of the product may be disrupted by electromagne-tic interference. If this is the case, switch the device off and on again following the instructions in the user manual. If the functions are not reset, move to another location.

SAFETY CIRCUIT :
During use, the internal power in the electric circuit can get quite high (for example during a 360 spin). In such a case safety circuit will shut down the vehicle for approximatively 1 minute. During this period the car will not respond to signals from the transmitter. This is not a defect but a safety measure to protect the electronic circuits. After this period, the car will resume normal operation.
Instruction sheet and packaging must be retained since it contains important information.

The toy must be operated in water only when fully assembled in accordance with the instructions

Safety precautions

• Parents: please read the instructions with your children before using the product for the first time.
• Stop the vehicle with the remote control before picking it up.
• Keep hands, hair and clothing away from moving parts when the toy is operating.
• Do not use the vehicle with the radio control in the street. Avoid collisions with people, animals and furniture.
• Warning: any change or modification made to this product that is not expressly approved in the relevant section of the declaration of conformity may terminate the usage authori-sation granted to the user.
• If battery cannot be charged, Please try another adapter.
• The product must only be used with the provided USB cable for charging.
• Do not use high output adapter for battery charging (1A or above).
• Transformer or battery charger used with the toy are to be regularly examined for damage to the cord, plug, enclosure and other parts, and in the event of such damage, they must not be used until the damage has been repaired.
• The wires are not to be inserted into socket outlets.

Battery warning

• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries should be charged under adult supervision.
• Different types of batteries or new and used batteries are not to be mixed.
• Only batteries of the same or equivalent type as recom-mended are to be used.
• Batteries are to be inserted with correct polarity. (+ and –)
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Do not mix old and new batteries.
• Do not mix alkaline batteries, standard batteries (car-bon-zinc) and rechargeable batteries (nickel-cadmium). CAUTION : first charge must be not less than 4h to opti-mize battery efficiency.

Care and maintenance

• Always remove the batteries from the toy if it is not used for a long time.
• Wipe the toy gently with a clean cloth.
• Keep the toy away from direct sources of heat.
• Replace batteries when they become less powerful.
• Operation temperature 5 – 35°C
• Receiver Category 3
• Do not immerse the product in water unless the battery com-partment is properly closed and locked.
• The toy is to be operated in water only fully assembled in accor-dance with the instructions.
• Do not drive in salty water.
• Operate on smooth water, such as pools and ponds.
• Never immerse remote control in water.
• Always remove product from water when not in use.
• Keep the product away from obstacles / peoples or animals in pool.
• This product is operated at either 27 or 40 MHz, please refer to the label on body part for clear reference.
  Frequency Band Range for 27MHz version: 26.957 – 27.283MHz Frequency Band Range for 40MHz version: 40.66 – 40.7MHz Maximum Radio-Frequency Power for both frequencies:<10mW

Batteries required for the transmitter
Power Supply
DC 3V / 0.2 W; 2×1.5V “AA” / LR6 / AM3 included

Batteries required for the car
Power Supply
DC 7.4V / 5 W; 350mAh / 7.4V Li-ion Battery Pack + USB included

SILVERLIT SAS
80, rue Barthelemy Danjou 92100 Boulogne-Billancourt France

References

• Certificate – Silverlit
• Our Story – Silverlit

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>