OLIGHT Odin IR Tactical Flashlight User Manual

OLIGHT Odin IR Tactical Flashlight

Thank you for purchasing this Olight Product. Please read this manual carefully before use and keep it for future reference!

IN THE BOX

Odin IR (with battery)

SPECIFICATIONS

WH (WHITE LIGHT)

IR LIGHT( WAVELENGTH 850NM )

• HIGH
  • 150mW Output 22h30min
• LOW
  • 30mW Output 91h

All above specifications are test results based on ANSI/NEMA FL1 Standard. The tests are performed when the built-in battery is fully charged

HOW TO OPERATE

• THREE LIGHT SETTINGS AVAILABLE: By rotating the ring at the head of the flashlight to select IR (infrared ray only), OFF, WH (white light only).

• TAIL SWITCH: Click the tail switch lightly to produce a low light output or press the tail switch hard to produce a high light output.

• CONSTANT ON/OFF : When the mode switch is not positioned to OFF, single click the tail switch for constant on. Click the tail switch again to turn it off.
  When the mode switch is positioned to OFF, all operations are disabled.

• MOMENTARY ON/OFF : When the mode switch is not positioned to OFF, press and hold the tail switch for momentary on. Release the switch and the light will go off

USB MAGNETIC CHARGING CABLE — MCC3

PRODUCT OVERVIEW

BATTERY INSTALLATION

Please remove the protective film on the lens; and please also unscrew the tailcap to remove the insulating film within the battery compartment, then screw the tailcap back on tightly. If the battery needs to be replaced, make sure that the positive end of the new battery faces the flashlight head when you put it in.

AVAILABLE BATTERIES

1 x customized 5000mAh 21700 rechargeable lithium battery

CHARGING

VIBRATING POWER INDICATOR

It helps to alert if the battery is low (power<20% vibrate once every 5 minutes; power<10% vibrate once per minute; powe r< 5% vibrate once every 10 seconds).

• Before first use please fully charge the product.
• Connect the USB end of the magnetic charging cable to an external USB power source, then attach the other end of the cable to the charging port of the light (best charging efficiency with a USB power source of no less than 10W (5V 2A) . The red indicator means charging, while the green indicat or means charging completed (battery level＞95%).
• Only charge with standard MCC3, not compatible with other MCC.

PRODUCT INSTALLATION

• Loosen the screws and install the rail mount in its desired position, then tighten the screws
• Slide the product into the rail mount until you hear a click, then turn the button 90 degrees clockwise as the mark shows to fix the product.
• Rotate the button 90 degrees counterclockwise to unlock the product as the mark shows
• Press the button and remove the product

REMOTE SWITCH INSTALLATION

1. Attach the magnetic remote switch to the tail of the product (make sure the detent ring of the remote switch is unlocked).
2. Push the ring forward to fix the remote switch.

**MAGNETIC REMOTE SWITCH

**

Quickly single click the button to turn the flashlight ON/OFF. When you press and hold the button, the flashlight will be in momentary mode; when you release the button, it will turn off. When in the OFF mode, the operation of the LO&HI buttons is disabled

DANGER

• DO NOT shine the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
• DO NOT cover the flashlight’s head or stand the flashlight on its head when it is on. The radiation energy may cause damage to the flashlight itself, or even result in the burning of flammable objects nearby.
• DO NOT use non-protected rechargeable batteries.

WARNING

• Keep out of reach of children.
• The tail switch may not work while immersed in sea water or other conductive media. Please try to keep it clean and dry.
• DO NOT disassemble the LEP module. Disassembly may result in irreversible damage.
• If the light is about to be put aside for a long time or be transported, please unscrew the tailcap and remove the battery to cut off the circuit.

NOTICE
DO NOT short-circuit the tail switch cap with the ring surrounding it. The short circuit in this case will result in an electric discharge of below 18mA between them, and may lead to a complete battery drain if it is in this state for too long.

EXCLUSION CLAUSE

Olight is not liable for damages or injuries sustained resulting from the usage of the product inconsistent with the warnings in the manual, including but not limited to using the product inconsistent with the recommended lockout mode

EU-Declaration of Conformity

EU-Declaration of Conformity can be found here : https://olightworld.com /ec-declaration

WARRANTY

• Within 30 days of purchase: Contact the original seller for repair or replacement.
• Within 5 years of purchase: Contact Olight for repair or replacement.
• Battery warranty: Olight offers a one year warranty for all rechargeable batteries.
• USB magnetic charging cable: One year.
• The other no warranty fragile or low-value fittings like lanyard andclip, you can contact post-sale in 30 days after purchase if it has quality drawback or damage under normal use condition. Over 30 days or damage under abnormal use condition, the conditional quality assurance will be provided as appropriate

USA Customer Support
cs@olightstore.com
Global Customer Support customer-service@olightworld.com
Visit www.olightworld.com to see our complete product line of portable illumination tools
Dongguan Olight E-Commerce Technology Co., Ltd 4th Floor, Building 4, Kegu Industrial Park,No 6 Zhongnan Road, Changan Town, Dongguan City, Guangdong, China.
Made in China

References

• Olight | Illuminate Your World.
• Flashlights, Tactical Light, Outdoor Tools - Olight Official Store- Olight

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>