TIMEX 10 LAP Ironman Essential 10 Full Size Resin Strap Watch User Guide

TIMEX 10 LAP Ironman Essential 10 Full Size Resin Strap Watch

Product Information

The product is a Timex watch with model number W89 which has two modes – 10 lap and 30 lap. It comes with an extended warranty and is water and shock- resistant. The watch has functions like time/date/hourly chime, chrono, timer, and alarm. The battery type is mentioned on the watch back and the battery life may vary depending on actual usage.

Product Usage Instructions

Basic Operation

• SET/RECALL OR DONE (To save changes and exit setting)
• MODE OR NEXT (Proceed to next step)
• START/SPLIT OR + (Increase value… Hold to increase rapidly)

When setting, each button has a different function as indicated above. Watch face will indicate when button changes function.

Time/Date/Hourly Chime

To set time/date/hourly chime:

1. Press MODE until time/date/hourly chime appears.
2. Use SET/RECALL or + buttons to set the time/date/hourly chime.
3. Press MODE or NEXT to proceed to the next setting.
4. Press DONE to confirm and exit setting.

Chrono

To use Chrono:

1. Press MODE until CHRONO appears.
2. Press and hold SET/RECALL.
3. Select LAP/SPL or SPL/LAP (format/set).
4. Use START/SPLIT to start the chrono.
5. Press STOP/RESET to stop the chrono.

Timer

To use Timer:

1. Press MODE repeatedly until TIMER appears.
2. Press SET/RECALL. Hour digits flash.
3. Follow the same pattern as setting TIME and ALARM to set hours, minutes, seconds, and select between REPEAT/AT END or STOP/AT END.
4. Press START/SPLIT to start the timer.
5. An alarm melody will chime when the timer has reached zero or before it starts to count down again.
6. Press STOP/RESET to stop the timer. Press again to reset to countdown time.

Alarm

To use Alarm:

1. Press MODE repeatedly until ALARM appears.
2. Press SET/RECALL to set alarm.
3. Press START/SPLIT or STOP/RESET to arm or disarm alarm. When disarmed, OFF the alarm goes off. Press any button to silence. A back-up alarm will sound after five minutes if you don’t press any buttons.

Water and Shock Resistance

The watch is water-resistant up to a depth of 30m/98ft or 50m/164ft depending on the model. It is not recommended for diving. Rinse the watch with fresh water after exposure to salt water. The watch is designed to pass ISO test for shock-resistance. However, care should be taken to avoid damaging crystal/lens.

Battery

Timex strongly recommends that a retailer or jeweler replace the battery. The battery type is mentioned on the watch back. If present, push/short internal reset switch after replacing the battery. Battery life estimates are based on certain assumptions regarding usage; battery life may vary depending on actual usage.
Do not dispose of the battery in fire. Do not recharge. Keep loose batteries away from children.

W89 098095000 11.27.18
Register your product at https://www.timex.com/product-registration.html

EXTENDED WARRANTY

Available in U.S. only. Extend your warranty for an additional 4 years from date of purchase for $5. You can pay with AMEX, Discover, Visa or MasterCard by calling 1 800-448-4639 during normal business hours. Payment must be made within 30 days of purchase. Name, address, telephone number, purchase date, and 5-digit model number required. You can also mail a check for $5 to: Timex Extended Warranty, P.O. Box 1676, Dept. EF, Little Rock, AR 72203.
Please read instructions carefully to understand how to operate your Timex® watch. Your model may not have all of the features described in this booklet.

FUNCTIONS

Real-time calendar clock, Second time zone, Countdown timer, Daily/weekday/weekend alarm, Hourly chime, Chronograph with lap/split storage, INDIGLO® night-light with Night-Mode® Feature.

BASIC OPERATION

When setting, each button has a different function as indicated above. Watch face will indicate when button changes function.

TIME/DATE/HOURLY CHIME

1. In TIME mode, press and hold SET/RECALL. Time zone will flash.
2. To set, push + or – to select first or second time zone.
3. Press NEXT. Hour digits flash.
4. Press + or – to change hour including AM/PM. (Scroll through 12 hours to  get to AM/PM).
5. Press NEXT. Minute digits flash.
6. Press + or – to change minutes.
7. Press NEXT. Second digits flash.
8. Press + or – to set seconds to zero.
9. Continue pattern to set month, day of month, year, 12-hour or 24-hour time display, MM.DD or DD.MM date format, turn hourly CHIME on/off, turn BEEP on/off. If you select BEEP on, a beep will sound every time you push a button (except INDIGLO®).
10. Press DONE to confirm and exit or NEXT to continue and set second time zone, if desired.
11. When in Time mode, press and hold START/SPLIT to “peek” at second time zone; hold for 4 seconds to switch time zones.

CHRONO

1. Press MODE until CHRONO appears.
2. Press and hold SET/RECALL.
3. The Display will read: FORMAT/SET, then select LAP/SPL or SPL/LAP options.
4. Press + or – to select desired format.
5. Press DONE to confirm and exit.
6. To use chrono, press START/SPLIT. Chrono continues to run even if you exit the mode.
7. Press STOP/RESET to stop chronograph from running OR while chrono is running, press START/SPLIT to take a split. Lap and split times will then be displayed in the format you selected. The lap number will alternate with the last two digits of the bottom line.

NOTES:

• Lap and split times will appear frozen for 10 seconds. Press MODE to release the display and see running chrono.
• While chronograph is running or stopped, press SET/RECALL, then press + or – to scroll through stored laps or to recall stored laps/splits. Press SET/RECALL again to return to running chronograph.
• Press and hold STOP/RESET to reset chronograph.

TIMER

1. Press MODE repeatedly until TIMER appears.
2. Press SET/RECALL. Hour digits flash.
3. Follow same pattern as setting TIME and ALARM to set hours, minutes, seconds, and select between REPEAT/AT END (timer counts down and then repeats) or STOP/AT END (the timer counts down and then stops).
4. Press DONE to confirm and exit.
5. Press START/SPLIT to start TIMER. Timer will continue to run even if you exit Timer mode. If REPEAT/END selected h will flash . If STOP/END selected H will flash.
6. An alarm melody will chime when the timer has reached zero or before it starts to count down again.
7. Press STOP/RESET to stop TIMER. Press again to reset to countdown time.

ALARM

Setting the ALARM is similar to setting TIME.

1. Press MODE repeatedly until ALARM appears.
2. Press SET/RECALL to set alarm.
3. Hour digits flash. Press + or – to change hour.
4. Press NEXT. Minute digits flash. Press + or – to change minutes.
5. Press NEXT. If in 12-hour format, AM/PM flashes. Press + or – to change.
6. Press NEXT. Press + or – to select DAILY, WEEKDAYS OR WEEKENDS.
7. Press DONE to confirm and exit.
8. Press Start/Split or Stop/Reset to arm or disarm alarm. When disarmed, OFF will be displayed. When armed, the alarm clock icon will appear t.
9. The INDIGLO® night-light and alarm icon flashes and an alert sounds when the alarm goes off. Press any button to silence. A back up alarm will sound after five mintues if you don’t press any buttons.

INDIGLO® NIGHT-LIGHT/NIGHT MODE® FEATURE

Press INDIGLO® button to activate night-light. Electroluminescent technology used in INDIGLO® night-light illuminates entire watch face at night and in low light conditions. While the night-light is on pressing any button keeps it on for three seconds.
Press and hold INDIGLO® button for 4 seconds to activate NIGHT-MODE® feature. Moon icon P will appear. Once activated, any button pushed will cause INDIGLO® night-light to stay on for 3 seconds. NIGHT-MODE® feature will stay activated for 8 hours or until deactivated by  pressing and holding INDIGLO® button again for 4 seconds.

WATER AND SHOCK RESISTANCE

If your watch is water-resistant, meter marking or (O) is indicated.*pounds per square inch absolute

WARNING : TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER WATER.

1. Watch is water-resistant only as long as lens, push buttons and case remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.
4. Shock-resistance will be indicated on watch face or caseback. Watches are designed to pass ISO test for shock-resistance. However, care should be taken to avoid damaging crystal/lens.

BATTERY

Timex strongly recommends that a retailer or jeweler replace battery. Battery type is on watch back. If present, push/short internal reset switch after replacing battery. Battery life estimates are based on certain assumptions regarding usage; battery life may vary depending on actual usage.
DO NOT DISPOSE OF BATTERY IN FIRE. DO NOT RECHARGE. KEEP LOOSE BATTERIES AWAY FROM CHILDREN.

TIMEX INTERNATIONAL WARRANTY

http://www.timex.com/productWarranty.html
©2018 Timex Group USA, Inc. TIMEX, INDIGLO and NIGHT-MODE are registered trademarks of Timex Group B.V. and its subsidiaries.
For more brand information please visit www.ironman.com
IRONMAN® and the “M-DOT” logo are registered trademarks of World Triathlon Corporation. Official Product of the IRONMAN TRIATHLON. Used here by permission.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>