Aqua One COP-10000 Float Aeration Fountain Pump User Manual

COP-10000 Float Aeration Fountain Pump
User Manual

Instruction manual
Float aeration fountain pump
COP-10000
Sites: 7-11

 COP-10000 Float Aeration Fountain Pump

All instruction manuals also online at: www.aquaristikwelt24.de
www.aquaristikwelt24.de
By Aquaristikwelt24
Thank you for choosing an AquaOne Float aeration fountain pump COP-10000. Read the user manual carefully before use to ensure you use the device properly.

Warranty

The guarantee period is 2 years, valid from the invoice date. The wear parts and the lamp are not covered by the warranty. The damage caused by improper use is excluded from the warranty.

Product features

1. This product is suitable for fish ponds, river aeration, landscape fountains, etc.
2. lt adopts floating installation and floats on the water surface automatically with the water level.
3. Frequency conversion technology is adopted, with low power, high efficiency and energy saving.
4. Oxygen-increasing spray seat, with wide spray diameter and 360-degree spray, has good oxygen-increasing effect and reduces the probability of fish diseases.
5. The filter screen type inlet cover isolates weeds and sundries to make water inflow smoother.
6. Ceramic rotating shaft, wear-resistant, rust-free, lang service life.

Product installation

1. Insert one end of the matching positioning rope into the positioning hole at the outer edge of the buoy (from two or three diagonal directions).
2. Tie the other end of the matching positioning rope firmly to the inserted bar.
3. Insert the inserted bar firmly into the mud along the outer edge of the pond to fix the product.
4. Note: When fixing, the motor part must be completely put into the water bottom to avoid dry burning damage of the motor.

Cleaning/maintenance

Safety tips shall be observed and the water pump shall be cleaned regularly to ensure its effective operation.

1. Cut off the power supply, remove the fixation, and take the product out of the water.
2. Remove the screws with a screwdriver, hold the main part of the water pump to separate the main part of the water pump from the buoy.
3. Rotate counterclockwise and remove the fixing frame.
4. Push the lock catch and rotate along the joint in a staggered way to separate the water filter cover from the lower shell of the main body.
5. Loosen the set screw to take out the rotor assembly.
6. Use a soft brush to clean a part under running water.
7. After cleaning, assemble the products in sequence.

Troubleshooting

The pump does not pump water or
insufficient pumping| Blockage of pump housing| Clean the pump housing
Impeller stuck| Clean the pump thoroughly
Air flows into the pump| Restart the pump

Winter

1. Remove the pump from the water.
2. Clean the pump thoroughly.
3. Check whether the pump and the power cord is damaged.
4. The pump should be stored in a frost-free place andin a container containing water as much as possible.

Note: Never immerse the connection plug in water.

Part lists

Technical parameter

Model: COP-10000
Voltage: 220 – 240 V/50Hz
Power: 90 W
Output: 20000 l/h
Fountain height: 1 m
Fountain diameter: 3 m
Power cord lenght: 10 m
Procuct size: 327x327x255 mm

The fountain can be connected in 2 different ways:
Variant 1:
You assemble the fountain exactly according to the instructions, then the fountain looks like this: Variant 2:
You remove “stainless steel strainer” under Part 3 of the exploded view and then the fountain looks like this:

www.aquaristikwelt24.de
By Aquaristikwelt24

References

• aquaristikwelt24

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>