WatchGuard T25-W Wireless Tabletop Firewall Appliance User Guide

T25-W Wireless Tabletop Firewall Appliance

Product Information

Models
This user manual provides information and instructions for the following models:

• BS2AE5
• BS2AE5W

Activation and Installation

To activate your Firebox, follow these steps:

1. Go to www.watchguard.com/activate
2. Log in to your WatchGuard account or create a new account. If you create a new account, return to the activation page after finishing the account creation process.

To install and set up your Firebox, follow these steps:

1. Make sure your computer is configured to use DHCP.
2. Connect your Firebox and power it on.
3. Go to https://10.0.1.1:8080.
4. Log in with the username “admin” and the passphrase “readwrite”.
5. Follow the directions in the Web Setup Wizard to configure your Firebox.
6. Install the Firebox in your network.

Product Usage Instructions

Connect Your Firebox and Power It On
Before you can connect to your Firebox, you need to connect it to power and your computer. Make sure your computer is configured to use DHCP. When you connect to the Firebox, it will assign an IP address on the 10.0.1.0/24 network.

Connect to the Web UI

To access the Web UI, follow these steps:

1. Go to https://10.0.1.1:8080.
2. Log in with the username “admin” and the passphrase “readwrite”.
3. Follow the directions in the Web Setup Wizard to configure your Firebox.
4. Install the Firebox in your network.

For more information, go to watchguard.com/start

Important Notes

If you’re using this product in the European Union or EFTA countries, except for France and Italy, it complies with the Electromagnetic Compatibility (EMC) directive and the Low Voltage Directive (LVD) of the European Union (EU). If you’re using this product in France or Italy, restrictive use applies. This product conforms to various European Union directives and standards. For more information, refer to the Declaration of Conformity included with this product.

CE Notice:
The CE symbol on your WatchGuard Technologies equipment indicates that it is in compliance with the Electromagnetic Compatibility (EMC) directive and the Low Voltage Directive (LVD) of the European Union (EU).

Europe – EU Declaration of Conformity (Wireless)
This device complies with the essential requirements of the RED 2014/53/EU. The following test methods have been applied in order to prove presumption of conformity with the essential requirements of the RED 2014/53/EU:

• EN 62368-1 – Safety of Information Technology Equipment
• EN 62311 – Assessment of electronic and electrical equipment related to human exposure restrictions for electromagnetic fields (0 Hz to 300 GHz)
• EN 300 328 – Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband Transmission systems; Data transmission equipment operating in the 2,4 GHz ISM band and using spread spectrum modulation techniques; Harmonized EN covering essential requirements under article 3.2 of the RED Directive
• EN 301 893 – Broadband Radio Access Networks (BRAN); 5 GHz high performance RLAN; Harmonized EN covering essential requirements of article 3.2 of the RED Directive
• EN 301 489-1 – Electromagnetic compatibility and Radio Spectrum Matters (ERM); ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical requirements
• EN 301 489-17 – Electromagnetic compatibility and Radio spectrum Matters (ERM); ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 17: Specific conditions for 2.4 GHz wideband transmission systems and 5 GHz high performance RLAN equipment
• EN 62368-1:2014+A11:2017

This device is a 5GHz wideband transmission system (transceiver), intended for use in all EU member states and EFTA countries, except in France and Italy where restrictive use applies. In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain authorization to use the device for setting up outdoor radio links and/or for supplying public access to telecommunications and/or network services. This device may not be used for setting up outdoor radio links in France and in some areas the RF output power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5 MHz. For detailed information the end-user should contact the national spectrum authority in France.

RoHS Statement
The member states of the European Union approved directive 2002/95/EC, Restrictions of Hazardous Substances (“RoHS directive”‘) that became valid on July 1, 2006. It states that all new electrical and electronic equipment put on the market within the member states must not contain certain hazardous materials. This device complies with the European Union’s R0HS directive 2002/95/EC and similar regulations that may be adopted by other countries for European Sales. To see additional certification information and languages, go to watchguard.com/start

Declaration of Conformity

WatchGuard Technologies, Inc. 505 Fifth Ave. S., Suite 500 Seattle, WA 98104 USA WatchGuard Technologies Inc. hereby declares that the product(s) listed below conform to the European Union directives and standards identified in this declaration.

Product (s):
WatchGuard Model: Firebox T25, Firebox T25-W, Hardware Model: BS2AE5, BS2AE5W

EU Directive(s): Low Voltage (2014/35/EU) Electromagnetic Compatibility (2014/30/EU) RoHS (2002/95/EC) WEEE Directive 2002/96/EC REACH EC 1907/2006 The Radio Equipment Directive (2014/53/EU)

Common Standard(s): EN 62368-1:2014+A11:2017 Safety for ITE EN 62311:2020 EN 55032:2015/A1:2020 Class A Emissions for ITE EN 55035:2017/A11:2020 Immunity for ITE EN IEC61000-3-2:2019/A1:2021 Class A EN 61000-3-3:2013/A1:2019 EN 61000-4-2:2009 EN 61000-4-3:2006+A1:2008+A2:2010 EN 61000-4-4:2012 EN 61000-4-5:2014+A1:2017 EN 61000-4-6:2014 EN IEC 61000-4-11:2020

Wireless Standard(s): EN 301 489-1 v2.2.3 EMC and Radio Spectrum Matters EN 301 489-17 V3.2.4 EMC and Radio Spectrum Matters EN 300 328 V2.2.2 Radio Spectrum Matters EN 301 893 V2.1.1 Broadband Radio Access Networks This device complies with Directive 2014/53/EU issued by the Commission of the European Community. Manufacturer / Hersteller: WatchGuard Technologies 505 5th Ave S. Suite 500, Seattle, WA 98104 USA Radio Equipment / Funkanlage: Wireless Access Point Type Designation / Typenbezeichnung: Firebox T25, Firebox T25-W Specifications / Technische Daten: 802.11a,b,g,n,ac (2.4GHz & 5GHz) Intended Purpose / Verwendungszweck: Network Firewall Appliance

The above device complies with the essential requirements and other relevant provisions to Directive 2014/53/EU when used for its intended purpose. This equipment may be operated in the USA, Canada, & Europe Union. Warning! This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. The frequency and maximum transmitted power limit in EU are listed as belows, 2412 – 2472 MHz: 20 dBm 5150 – 5350 MHz: 20 dBm Restrictions

WATCHGUARD TECHNICAL SUPPORT

• 1.877.232.3531 (U.S. and Canada)
• +1.206.613.0456 (all other countries)
• www.watchguard.com/support
• ADDRESS : 505 Fifth Avenue South, Suite 500, Seattle, WA 98104
• U.S. SALES : 1.800.734.9905
• INTERNATIONAL SALES: +1.206.613.0895
• WEB : www.watchguard.com

© 2022 WatchGuard Technologies, Inc. All rights reserved. WatchGuard, the WatchGuard Logo, Fireware, and LiveSecurity are registered trademarks of WatchGuard Technologies, Inc. in the United States and/or other countries. All other trademarks and tradenames are the property of their respective owners. P.N. 352-T250-001 060822 Rev A

References

• WatchGuard Technologies | Network Security, Secure Wi-Fi, MFA, and Endpoint Security Solutions
• WatchGuard Technologies | Network Security, Secure Wi-Fi, MFA, and Endpoint Security Solutions
• Loading...
• WatchGuard Support | Download Software & Activate Products

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>