MSI GM51 Lightweight Wireless User Guide
- June 9, 2024
- MSI
Table of Contents
MSI GM51 Lightweight Wireless
Overview
- Left Button
- Right Button
- Scroll Wheel
- Side Button 1 (Default Setting: Next Page)
- Side Button 2 (Default Setting: Previous Page)
- MSI Diamond Light Grip
- Dragon RGB LED Light
- Portable Fraxion Free Cable
- DPI Switch
- Slider Switch: 2.4G Mode/Bluetooth Mode/Off
- Optical Sensor
- Charging Port
- PTFE Skates
- Wireless USB Dongle
- Charging Pin (For charging the CLUTCH GM51 LIGHTWEIGHT WIRELESS)
- Dongle Port (Used when MSI Dongle is inserted)
- USB Type-C Connector
- Charger Anti-Slip Strip
LED Indicators Adjustment
Use the following buttons in combination repeatedly until the preferred selection is made.
- DPI Switch + Left Button = Fade Off Speed
- DPI Switch + Right Button = adjust the LED brightness levels
- DPI Switch + Scroll Wheel = select a LED Lighting Effect
- DPI Switch + Side Button 1 = adjust the Lighting Effect Speed
- DPI Switch + Side Button 2 = select a LED Color
※ For more information, please visit MSI official website.
Bluetooth Paring
- Turn off the power
- Press and hold the DPI button
- Set the Slider Switch to Bluetooth mode, keep holding the DPI button for 5 secs then release it to activate the pairing mode.
- Activate Bluetooth on your device and select “MSI GM51” from the list of devices found.
- Support Microsoft Swift Pair.
level DPI Presets
The higher DPI will be recommended to the monitors with higher resolution. Press repeatedly the DPI switch located underneath the mouse until the preferred selection is made.
| LED color | DPI |
|---|---|
| Blue | 400 |
| Purple | 800 |
| Red | 1600（default） |
| Yellow | 3200 |
| Green | 6400 |
Battery Capacity Indicator
Read the color of the Dragon RGB LED indicator to learn the battery capacity of the mouse.
| Battery capacity | LED color |
|---|---|
| 90% – 100% | Steady Green |
| 70% – 90% | Breathing Green |
| 50% – 70% | Breathing Yellow |
| 30% – 50% | Breathing Orange |
| 10% – 30% | Breathing Red |
| 0% – 10% | Flashing Red |
| Battery capacity | LED color |
| 90% – 100% | Steady Green |
| 70% – 90% | Breathing Green |
| 50% – 70% | Breathing Yellow |
| 30% – 50% | Breathing Orange |
| 10% – 30% | Breathing Red |
| 0% – 10% | Flashing Red |
- Battery Percentage (%) can also be found in Dragon Center MSI Center
- Rated Voltage Current : 5V 600mA；Maximum Operating Temperature : 40 °C
- For more information, please visit MSI official website
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (
- This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-
* Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Any changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the device. Where shielded interface cables have
been provided with the product or specified additional components or accessories elsewhere defined to be used with the installation of the product, they must be used in order to ensure compliance with FCC regulations.
Services web address: www.msi.com
CE宣告：Hereby, MSI declares that the radio equipment type 8ZB5 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.msi.com
BSMI Statement
- Replacement of battery with an incorrect type that can defeat a safeguard (for example, in the case of some lithium battery types);
- Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
- Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;
- A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
ISED Compliance Statement
This device contains licensee exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licensee exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>