PARAGON OUTDOOR OH-M744S 810010536464 82.5 Inch 32000 BTU Paragon Shine Propane Flame Tower Heater User Guide
- June 4, 2024
- PARAGON OUTDOOR
Table of Contents
PARAGON OUTDOOR OH-M744S 810010536464 82.5 Inch 32000 BTU Paragon Shine
Propane Flame Tower Heater
Unscrew the switch button
Insert AA alkaline battery tighten the switch button.
BEFORE TURNING GAS SUPPLY ON
Your heater was designed and approved for OUTDOOR USE ONLY, do not use it inside of a building, garage or any enclosed area. Make sure the surrounding area is free of combustible materials, gasoline, and other flammable vapors or liquids Ensure that there are no obstructions to air ventilation. Be sure all gas connections are tight and there are no leaks Be sure the cylinder cover is clear debris. Be sure any component removed during assembly or service is replaced and fastened prior to starting.
BEFORE LIGHTING
Heater should be thoroughly inspected before each use, and by a qualified technician annually.
NOTE
Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear.
Suspected areas should be leak tested. If the hose leaks, it must be replaced
prior to operation. Only use the replacement hose specified by Paragon
Outdoor.
USE AND CARE
Note
For initial start or after any cylinder change, hold control knob in for 2
minutes to purge air from gas lines before proceeding.
NOTE
This heater is equipped with a pilot light that allows for safer start- ups
and shutdowns. Pilot must be lit before burner can be started.
NOTE
Make sure gas hose is securely affixed to tank and open valve completely
before use.
WARNING
ALWAYS PERFORM A LEAK CHECK AFTER PROLONGED STORAGE
PILOT
Push control knob and rotate counterclockwise until it stops at the pilot position. Push the IGNITOR BUTTON until pilot flame is visible through the glass tube. Once the pilot is lit, continue to depress the control knob for 30 seconds.
START
Push in and turn the control knob to the HIGH then release control knob.
Note
If pilot fails to remain lit, all valves should be closed and a waiting period
of at least 5 minutes should pass before attempting to light.
ADJUST
If you want a lower tempera- ture, push in the control knob and turn counterclockwise to the LOW position.
Ignitor button
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>