Gearmo GM-HU32ES 2-Port USB 3.2 Gen 1 Industrial Surface and DIN Rail Mount Hub User Manual
- June 9, 2024
- Gearmo
Table of Contents
User Manual
2-Port USB 3.2 Gen 1 Industrial Surface &
DIN-Rail Mount Hub w/ Gigabit Ethernet & DB9 FTDI Serial
Model No. GM-HU32ES
Introduction
- Thank you for purchasing Gearmo’s 2-Port USB 3.2 Gen 1 Industrial Surface & DINRail Mount Hub w/ Gigabit Ethernet & DB9 Serial FTDI Chipset! Please read the manual in detail first before you begin using this hub. The specifications are subject to change without notice.
System Requirements
- Desktop or Notebook Computer with an Available USB Type-A or USB Type-C Port
- Windows 11 (64-bit), 10 (32/64-bit), 8 (32/64-bit), 7 (32/64-bit)
- Mac OSX Lowest or Latest Versions
Package Contents
- Industrial 2-Port USB & Serial 3.2 Gen 1 Hub
- User Manual
- Power Adapter with DC Barrel Connector
- USB Type-A to Type-B Cable
- DIN-Rail & Wall Mounting Kit
- 3-Pin Terminal Block
- Screw Package
- Driver Disc
Hub Layout
Installation
-
Power
– The USB 3.2 Gen 1 Hub requires a 9~48V DC external power source to work.
– Power up the USB Hub through either the Included DC Power Jack Adapter or 3-Pin Terminal Block. -
3-Pin Terminal Block
– Plug the included terminal block to the hub’s terminal block connector. -
Hardware
– Mount your hub on the Wall, Surface or Din Rail, if needed.
DIN Rail Mounting
- Use the included screws to install the DIN Rail Clip to the hub.
- Insert the top of the DIN Rail Clip onto the DIN Rail Track, then gently push the bottom of the hub to secure it to the DIN Rail Track.
Surface / Wall Mounting
- Use the included screws to affix the surface mounting flanges to the hub. Use surface mounting screws attach hub to the wall or smooth surface (surface mounting screws not included).
Specifications
- Support all USB 1.1 to 3.2 Gen 1 compatible peripheral device data transfer upto 5Gbps
- Support Ethernet 10/100/1000 Mbps
- Single RS232
- 9-48V DC input
- Support LED indicator
- Supported OS Systems Windows 11/10/8/7 and Mac OS
- Support USB 3.0 plug and play
- 15KV ESD surge protection
- Operating temperature 0-50C
Windows Installation
RS-232
- Put the driver CD in the CD ROM driver
- Open the path: “CD ROM-driver\FTDI drivers\Setup.exe”, afterwards click next.
- Click finish to complete the installation.
- Open device manager to make sure that the driver was installed successfully.
- You can now start to use the device.
Ethernet Port
- Put the driver CD in the CD ROM driver
- Open the path: “CD ROM-driver\realtek drivers\Setup.exe”, afterwards click next.
- Click finish to complete the installation
- Open device manager to make sure that the driver was installed successfully.
- You can now start to use the device.
Documents / Resources
|
Gearmo GM-HU32ES 2-Port USB 3.2 Gen 1 Industrial Surface and DIN Rail Mount
Hub
[pdf] User Manual
GM-HU32ES 2-Port USB 3.2 Gen 1 Industrial Surface and DIN Rail Mount Hub, GM-
HU32ES, 2-Port USB 3.2 Gen 1 Industrial Surface and DIN Rail Mount Hub,
Surface and DIN Rail Mount Hub
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>