LANDI 16897.01 Hanging Lamp Solar 24.5 × 30 cm Instruction Manual

: June 9, 2024
: LANDI

Table of Contents

LANDI 16897.01 Hanging Lamp Solar 24.5 × 30 cm
Mounting drawing
Safety directions
Assembly
Replacement of battery
Technical data
Manufactured
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LANDI 16897.01 Hanging Lamp Solar 24.5 × 30 cm

LANDI-16897-01-Hanging-Lamp-Solar-24-5-30-cm-PRODACT-
IMG

Mounting drawing

LANDI-16897-01-Hanging-Lamp-Solar-24-5-30-cm-FIG-1

Safety directions

Safety directions / Please read this information carefully before installing or using this product. Please keep this user manual for further reference.

The manufacturer does not accept any responsibility for injuries or damage resulting from improper use of the product.
Maintenance of the product is limited to its surfaces.
The product has a protection rating of IP44 (“splash water proof”) and is solely intended for use in private households.
Do not hang any objects on the lamp and do not cover it with any other objects.
The light source of this product is not replaceable. When the light source has reached the end of its life, the entire product must be replaced.
Do not look directly into the light source (illuminant, LED, etc.).
LED colour deviation when using different lots may occur. The light colour and luminous strength of the LEDs can also change as a result of battery life span level.
During the day, the solar panel of the solar lamp converts the incoming sunlight into electricity and charges the battery. In the dark, the solar light turns on automatically and the electricity stored during the day will be used.
The lighting time of the solar lamp depends on your geographical location, weather conditions and the level of seasonal daily light. Solar lights get less exposure to direct sunlight during winter. Therefore, the light output duration will be lower in winter.
Batteries or rechargeable batteries are not permitted in domestic waste. They must be decontaminated according to the regulations of the responsible authorities as hazardous waste. Use the available collection points.
Swallowing batteries can cause chemical burns, perforation of soft tissue, and death. Severe burns may occur within 2 hours of swallowing batteries. Seek immediate medical attention.
Keep batteries out of reach of children. If accidentally swallowed seek immediate medical attention.
Never throw batteries into fire or water. Do not exert mechanical loads to batteries.
Avoid extreme environmental conditions and temperatures, which could affect batteries, e.g. radiators.
In the event of contact with battery acid, thoroughly flush the affected area with plenty of clean water and seek immediate medical attention. Avoid contact with the skin, eyes and mucous membranes.
Leaked or damaged batteries can cause burns on contact with the skin. Wear suitable protective gloves at all times if such an event occurs.
In the event of a leakage of batteries, immediately remove them from the product to prevent damage.
Only use the specified type of rechargeable battery!
Insert batteries according to polarity marks (+) and (-) on the battery and the product.
The symbol of the crossed-out garbage can on the product or the packaging means that the product must not be disposed with ordinary household waste. At the end of its useful life, the product must be returned to a point of acceptance for the recycling of electric and electronic device. Please ask your local municipality for the point of acceptance.

Assembly

Remove the product from the packaging.
Check if all parts are included.
The product is equipped with a switch on the bottom side of the solar panel. Use this switch to turn the product on / off.
Place the lamp on a horizontal, flat surface. Alternatively, the product can also be installed as a hanging lamp by using the chain and hook. Make sure that the lamp is securely attached!
Before using the solar light for the first time, charge it in direct sunlight for two days to ensure that the battery is fully charged. For charging, the switch must be switched to “ON” position. The product is now ready for use.

Replacement of battery

Once the battery has reached the end of its lifespan, you may choose to replace it with a new battery of the same type.

Remove the light unit including the solar panel by turning it counterclockwise out of the holder.
Ensure that the switch is in OFF position.
Loosen the screws on the bottom of the solar panel and open the housing to expose the battery compartment.
Remove the old battery carefully and replace it with a new battery of the type as mentioned under “Technical data”.
Close the battery compartment using the screws previously removed.
Set the switch to position ON
Attach the light unit including the solar panel to the holder by turning it clockwise.

The product is now ready for operation again.