SONANCE IS-ENCL-S Invisible Series Sound Isolating Enclosure Instruction Manual
- June 9, 2024
- Sonance
Table of Contents
INVISIBLE SERIES SOUND ISOLATING ENCLOSURE
INSTALLATION INSTRUCTIONS
INTRODUCTION
Sonance Invisible Series Sound Isolating Enclosures reduce sound transmission
into rooms that are adjacent to speakers mounted in walls or in ceilings.
For the enclosures to be effective, it is important that they are installed
according the following directions to ensure a tight seal with the speaker.
INSTALLATION
Step 1
Route the wire from the IS speaker through the air tight connector on the
enclosure. You might need to loosen the nut on the air tight connector to
allow the wire to pass through easily.
Step 2
Place the speaker on a flat surface. Place the enclosure in the groove on the
back of the IS speaker baffle. Use the provided screws to attach the enclosure
to the speaker.
NOTE: MAKE SURE THAT THE RUBBER GASKET REMAINS UNDER THE EDGE OF THE ENCLOSURE.
To ensure that the gasket sits properly, tighten the screws in a crisscross
and diagonal pattern. Apply an equal amount of torque to each screw.
IMPORTANT: ALWAYS USE LOW-TORQUE SETTINGS. NEVER OVER TIGHTEN.
Step 3
Tighten the nut on the air tight connector to seal up the enclosure and
capture the speaker wire. Connect the wires from your amplifier to the speaker
wires normally.
NOTE: ALL SONANCE INVISIBLE SERIES SPEAKER AND SUBWOOFER MODELS MODELS HAVE A 3.39” (86MM) MOUNTING DEPTH WHEN INSTALLED WITH THE SOUND ISOLATING ENCLOSURE. (MODELS IS8T, IS6T, AND IS15W INCLUDE THE ENCLOSURE BUILT IN AND DO NOT REQUIRE THIS ACCESSORY).
For additional information please scan the code.
LIMITED FIFTEEN (15) YEAR WARRANTY
Sonance warrants to the first end-user purchaser that this Sonance-brand
product (“Product”), when purchased from an authorized Sonance
Dealer/Distributor and installed by a Sonance installer, will be free from
defective workmanship and materials in the initial installation for the period
stated below. Subject to the additional limitations stated below, Sonance will
(a) at its option and expense during the warranty period, either repair the
defect or replace the Product with a new or remanufactured Product or a
reasonable equivalent, and (b) arrange at its reasonable expense to re-install
the Product and prepare the surface of the speaker and/or mounting platform
for finishing and nothing more.
EXCLUSIONS TO THE EXTENT PERMITTED BY LAW, THE WARRANTY SET FORTH ABOVE IS IN
LIEU OF, AND EXCLUSIVE OF, ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, AND IS
THE SOLE AND EXCLUSIVE WARRANTY PROVIDED BY SONANCE. ALL OTHER EXPRESS AND
IMPLIED WARRANTIES, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY, IMPLIED
WARRANTY OF FITNESS FOR USE, AND IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR
PURPOSE ARE SPECIFICALLY EXCLUDED.
No one is authorized to make or modify any warranties on behalf of Sonance.
The warranty stated above is the sole and exclusive remedy and Sonance’s
performance shall constitute full and final satisfaction of all obligations,
liabilities and claims with respect to the Product. IN ANY EVENT, SONANCE
SHALL NOT BE LIABLE FOR CONSEQUENTIAL, INCIDENTAL, ECONOMIC, PROPERTY, BODILY
INJURY, OR PERSONAL INJURY DAMAGES ARISING FROM THE PRODUCT, ANY BREACH OF
THIS WARRANTY OR OTHERWISE.
This warranty statement gives you specific legal rights, and you may have
other rights which vary from state to state. Some states do not allow the
exclusion of implied warranties or limitations of remedies, so the above
exclusions and limitations may not apply. If your state does not allow
disclaimer of implied warranties, the duration of such implied warranties is
limited to the period of Sonance’s express warranty. Your Product Model and
Description: Sonance BPS6 TL SLOT CONNECTOR Warranty Period for this Product:
Fifteen (15) years from the date on the original sales receipt, invoice or
other satisfactory proof of purchase. Additional Limitations and Exclusions
From Warranty Coverage: The warranty described above is non-transferrable,
applies only to the initial installation of the Product, does not include re-
finishing of the speaker and/or mounting platform or surrounding surface, does
not include damage to allied or associated equipment which may result for any
reason from use with this Product, and does not include Product failure caused
by accident, disaster, negligence, improper installation, misuse (e.g.
overdriving the amplifier or speaker, excessive heat or cold or humidity,
outdoor installation), or from service or repair which has not been authorized
by Sonance. Obtaining Authorized Service: To qualify for the warranty, you (1)
must contact your authorized Sonance Dealer/Installer or call Sonance Customer
Service at 949-492-7777 within the
warranty period, (2) must obtain a return merchandise number (RMA), and (3)
deliver the Product to Sonance shipping prepaid during the warranty period,
together with the original sales receipt, invoice or other satisfactory proof
of purchase.
©2022 Sonance. All rights reserved. Sonance is a registered trademark of Dana
Innovations. Due to continuous product improvement, all features and
specifications are subject to change without notice. For the latest Sonance
product specification information visit our website: www.sonance.com
SONANCE
• 991 Calle Amanecer
• San Clemente, CA 92673
• 949-492-7777
• FAX: 949-361-5151
• Technical Support: 949-492-7777
01.12.2023
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>