Verifone UX7002 Point of Sale Terminal User Manual
- June 9, 2024
- Verifone
Table of Contents
Verifone UX7002 Point of Sale Terminal
External Power Supply
UX series are intended to be provided with a Listed Power Supply module which is evaluated as a Limited Power Source or PS or e univalent and has an output rating as follows: For UX700-W U-2: 9- 3V DC, .4-0.5A
The location I Electrical Considerations
CAUTION: Due to the risk of electrical shock or unit damage, do not use the unit near water, including a bathtub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool. Also, avoid using this product during electrical storms.
Avoid locations near electrical appliances or other devices that cause excessive voltage fluctuations or emit electrical noise, for example, air conditioners, neon signs, high- fre uency or magnetic security devices, or electric motors.
Equipment
Location – Environmental Considerations Do not plug the power pack into an outdoor outlet. Ihe terminal is not waterproof or dust proof and should not be used outside the normal operating temperature range. Any damage to the unit from exposure to water or dust may void your warranty. Do not use the device where there is high heat, dust, humidity, moisture, or caustic chemicals or oils. Keep the device away from direct sunlight and anything that radiates heat, such as a stove or a motor.
WARNING! Your device contains sensitive electronic components that can be permanently damaged if exposed to excessive shock or vibration. To minimize the risk of damage to your device, avoid dropping your device and operating it in high-shock and high-vibration environments. Do not store the device where prolonged exposure to extreme temperature can occur, because it can cause permanent damage. Do not expose the device to water. Contact with water can cause this unit to malfunction.
Repairs
Do not, under circumstances, attempt any service, adjustments, or repairs on this equipment. Instead, contact your local Verifone distributor or service provider for assistance. Failure to comply may void the product warranty.
Notice for WLAN
- For CE WLAN: 5150-5350 MHz This device is restricted for indoor use only when operating in the 5150 to 5350 MHz frequency range.
- For UK WLAN: 5150-5350 MHz This device is restricted for indoor usage in UK when operating in the 5150 to 5350 MHz frequency range.
This e uipment may be operated in:
AT| E| | HR| CY| C| DK| EE
FI| FR| DE| EL| HU| IE| IT| LV
LT| LU| MT| NL| PL| PT| RO| SK
SI| ES| SE| UK| IS| LI| NO| CH
TR| | | | | | |
FCC INFORMATION
For IC
- The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems.
- Where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly indicated.
Coin Cell Instruction
Dispose of ot the battery pack In accordance with all national, state,
and local laws and regulations as regionally required. Some batteries may be
recycled and may De accepted for disposal at local Tecycin9 centers.
CAUTION: There is a risk of explosion if the battery is replaced by an
incorrect type.
FCCIISED Compliance The following product has been tested and certified as compliant with the regulations and guidelines detailed below:
- Manufacturer: Verifone, Inc.
- Brand: Verifone
- Model: UX700-WBU-2
Part 15 of FCC and ISED Rules This device complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules and innovation, science and Economic Development Canada license-exempt RSS standard(s) which provides reasonable protection against harmful interference in a residential area.
Operation is subject to the following conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment generates and uses radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that inteference will
not occur in a particular installation. In the unlikely event that there is
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures
Reorient or relocate the receiving antenna. Increase the separation between
the equipment and the receiver. Connect the equipment to an outlet on a
circuit different from that to which the receiver is connected. Consult with
the dealer or ask an experienced radio/TV technician for help. This device and
its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter. The use of a shielded interface cable is
required to comply with the Class B limits of Part 15 of FeC Rules.
| Feature | UX700-W U-2 |
|---|
NFC d A m at 0m ,
3.56 MHz
| ****
s a
. WLAN: 0 . b g n EIRP d m
– 7 MHz
|
5 WLAN: 0 . a n 0 n 0 EIRP d m
5 0-5 0 MHz, 5 60-53 0 MHz; 5500-5700
MHz
|
T- EDR LE EIRP d m
0 – 0 MHz
| s a
UW| – 87 a
SAR Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To comply with Council Recommendation Radio Equipment 2014/35/EU, UK Radio Equipment Regulations 2017 SI 2017/1206, ISED RSS-102 and FCC RF exposure requirement, a minimum separation distance of 20 cm must be maintained between the user’s body and the device, including the antenna. Conditions that do not meet these requirements may not comply with Council Recommendations 2014/35/EU, UK Radio Equipment Regulations 2017 SI 2017/1206, IC RSS-102, and FCC RF exposure requirements and should be avoided.
Legal Terms and Conditions Regarding PCI SSC Approvals
PCI SSCs approval only applies to PEDS that are identical to the PED tested by a PCI Security Standards Council-recognized laboratory. If any aspect of the PED is different from that which was tested by the laboratory even if the PED conforms to the basic product description contained in the letter, then the PED model should not be considered approved, nor prompted as approved. For example, if a PED contains firmware, software, or physical construction that has the same name or model number as those tested by the laboratory, but in fact are not identical to those PED should not be considered or prompted as approved. any aspect of a vendor or its PEDs, except to the prohibited extent and subject to the terms and restrictions expressly set forth in a written agreement with PCI SSC, or in an approval letter. Áll other references to PCI sSC’s approval are strict and active When granted, approval is provided by PCI SSC to ensure certain security and operational characteristics important to the achievement of PCi ssCs goals, but the approval does not under any circumstances include any endorsement or warranty regarding the Functionality, quality, or pertormance or any particular product or service. CSS does not warrant any products or services provided by other third parties. Approval does not, under any circumstances, include or imply any product warranties from PCI SSC, including, without limitation, any implied warranties of merchantability, fitness for purpose or noninfringement, all of which are expressly disclaimed by PCI SSC. All rights and remedies regarding products and services, which have received approval, shall be provided by the party providing such products or services, and not by PC SSC or the payment brand participants.
Equipment Installation Warning for Indoor Use: The use of outdoor mounted antennas, e.g., antennas mounted on the outside of a building or on a telephone pole, or any other outdoor infrastructure is prohibited.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>