4lite 4L2-3002 Marinus Outdoor IP44 Wall Light With PIR Sensor Anthracite Instruction Manual

June 9, 2024
4lite

4lite 4L2-3002 Marinus Outdoor IP44 Wall Light With PIR Sensor Anthracite

4lite 4L2-3002 Marinus Outdoor IP44 Wall Light With PIR Sensor
Anthracite

Warranty Information

For warranty details please contact your local representative or visit our website: www.anselluk.com
It is highly recommended that all Ansell luminaires are installed / maintained by a fully qualified electrician and wired in accordance to the latest IEC standards or national equivalent. Mains power must be switched off during any installation or maintenance. Should the product fail during the warranty period, Ansell will repair or replace the product in question. Ansell do not accept any responsibility for any installation costs associated to the replacement of this product. “Please Note – The warranty period shall be null and void in the following circumstances: Failure by the installer, end user or any third party to exercise caution to protect any covered product or part from outside damage, adverse temperature, humidity conditions, fluctuations in the electrical system or physical abuse as well as failure related to poor workmanship in the installation of the products or parts. lnabiUty to provide correct product information. Any questions or concerns with the product, please contact your local representative.

Ansell Electrical Products

  • Unit 6B, Stonecross Industrial Park, Yew Tree Way, Warrington, WA3 3JD
  • Ansell (Sales & Distribution) Unit 2, M2 Business Park, Duncrue Street, Belfast, BT3 9AQ
  • Ansell (Sales & Distribution) Republic of Ireland Limited Unit G1, Block G, Calmount Park, Calmount Avenue Dublin 12, D12 TH56

INSTALLATION INSTRUCTION

4lite 4L2-3002 Marinus Outdoor IP44 Wall Light With PIR Sensor Anthracite
1

SET TIMER

4lite 4L2-3002 Marinus Outdoor IP44 Wall Light With PIR Sensor Anthracite
2

SET SENSOR

4lite 4L2-3002 Marinus Outdoor IP44 Wall Light With PIR Sensor Anthracite
3

HOW TO CHANGE INTO MANUAL

  1. When power on, the PIR detector enters Into the “WARM-UP” perlods for about1 minute, then automaticaly change into AUTO MODE
  2. During AUTO MODE, by swltching the ON/OFF maln swtoch for 2 times within 3seconds then swltch on, the PIR detector w change Into MANUAL MODE from AUTO MODE. In MANUAL MODE, the Lamp(s) will remain ON In MANUAL MODE the PIR detector not affected automatically by duration time and Lux control level.
  3. Durlng MANUAL MODE or AUTO MODE, swtching off the ON/OFF maln seconds and then on again, the PIR detector will reset to WARM-UP perlbds. Please note: the perlods of “WARM-UP maybe be shorter than 1 minute. by switch over 6

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals