AOC AD110D0 Ergonomic Monitor Arm Instruction Manual
- June 9, 2024
- AOC
Table of Contents
AOC AD110D0 Ergonomic Monitor Arm
AOC Ergonomic Monitor Arm
Model：AD110D0
Packaging List
Clamp-Mounting Procedures
STEP 1
- Tighten the 3pcs of Screws (black only) to the arm base.
- Once you have Secured the L-Shaped bracket to the base, attach the turner apparatus to the bracket.
Step 2
Place (H) plastic plate on the desk surface before placing arm base
Step3
Once base (B) is secured to the desk, place the arm (A) to the base
Hole-Mounting Procedure
Step1
Insert screws from(G) into (J) Plate, tighten the 3 screws (F) onto the arm
base.
Step 2
Place piece (|) onto the ong screw (G) first, then utilize the wingnut
provided to secure the base to the surface you are attaching the arm(s) to.
Step 3
Step 4
When monitor arms are placed in correct position,tighten the hidden screw to
lock in monitors arm from shifting.
Cable Management
Installing VESA Mount
Step 1
Step 2
Monitor Weight Adjustment
“+” Increase holding capcacity
“-” Decrease holding capacity
Once monitor is stable, tighten top 2 and bottom 2 as well.
Noted: Please ensure monitor is within 2-9kg weight range
Condition
- After attached monitor, your monitor is freely moveable in any direction without adjustment.
- After monitor is attached, if screen will bounce up, pls use rench provided and turn “” clockwise direction until stablized.
- After monitor is attached, if screen will sink,pls use rench provided and turn “+” clockwise direction until stablized.
Adjust Monitor angles
AFTER INSTALLATION, ADJUST GAS-SPRING POWER
warning
- Ensure the Monitor is tightened to Monitor Arm
- Ensure Monitor is not Over-weighted (2-9kg)
Weight Adjustment
Warning
SPECIFICATION
- Monitor Size: 13~32″
- Weight Capacity: 2~9kg（4.09~19.84 LB）
- VESA Size: 75x75mm, 100x100mm
Envision Peripherals, Inc.
490 N.Mcarthy Blvd. Suite #120
Milpitas, CA 95035
www.aoc.com
Made in China