HYPERX HX430C16PB3A/32 32GB 4G x 64-Bit DDR4-3000 CL16 288-Pin DIMM Ram User Guide
- June 9, 2024
- HYPERX
Table of Contents
HYPERX HX430C16PB3A/32 32GB 4G x 64-Bit DDR4-3000 CL16 288-Pin DIMM Ram
DESCRIPTION
HyperX HX430C16PB3A/32 is a 4G x 64-bit (32GB)
DDR4-3000 CL16 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen
2G x 8-bit FBGA components per module. Each module kit supports Intel® Extreme
Memory Profiles (Intel® XMP) 2.0. Each module has been tested to run at
DDR4-3000 at a low latency timing of 16-18-18 at 1.35V. The SPDs are
programmed to JEDEC standard latency DDR4-2400 timing of 17-17-17 at 1.2V.
Each 288-pin DIMM uses gold contact fingers. The JEDEC standard electrical and
mechanical specifications are as follows:
XMP TIMING PARAMETERS
- JEDEC: DDR4-2400 CL17-17-17 @1.2V
- XMP Profile #1: DDR4-3000 CL16-18-18 @1.35V
- XMP Profile #2: DDR4-2666 CL16-18-18 @1.2V
SPECIFICATIONS
- CL(IDD) 17 cycles
- Row Cycle Time (tRCmin) 45.75ns(min.)
- Refresh to Active/Refresh Command Time (tRFCmin) 350ns(min.)
- Row Active Time (tRASmin) 32ns(min.)
- UL Rating 94 V – 0
- Operating Temperature 0o C to +70o C
- Storage Temperature -40o C to +85o C
FEATURES
- Power Supply: VDD = 1.2V Typical
- VDDQ = 1.2V Typical
- VPP = 2.5V Typical
- VDDSPD = 2.4V to 3.3V
- On-Die termination (ODT)
- 16 internal banks; 4 groups of 4 banks each
- Bi-Directional Differential Data Strobe
- 8 bit pre-fetch
- Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
- HyperX Infrared Sync working distance 18mm
- Factory preset RGB wave lighting effect
- Height 1.661” (42.20mm)
MODULE WITH HEAT SPREADER
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
The product images shown are for illustration purposes only and may not be an exact representation of the product. Kingston reserves the right to change any information at anytime without notice.
FOR MORE INFORMATION, GO TO WWW.KINGSTON.COM/HYPERX
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2020 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley,
CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property
of their respective owners.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>